Additional tie down points in cab?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Double check the threads when you use those as anchor points. I seem to remember something about federal rules for a SAE size thread for one or both of those. It might be a newer regulation.
Also, some vehicles have rust around the seat anchors in the 3rd row, check your sheet metal as well

Correct. All seat belt bolts are SAE 11/16 fine thread. On all cars.

nukegoat, you can also use the child-seat tether points in the floor if you drill and use a large backing washer. The standard for race cars is 2sq.in of area for seat belts. Any race car supply shop can supply eye bolts for seat belts. Actually your local parts stores may have these parts as well, if they sell 5/6pt harnesses.
 
Correct. All seat belt bolts are SAE 11/16 fine thread. On all cars.

nukegoat, you can also use the child-seat tether points in the floor if you drill and use a large backing washer. The standard for race cars is 2sq.in of area for seat belts. Any race car supply shop can supply eye bolts for seat belts. Actually your local parts stores may have these parts as well, if they sell 5/6pt harnesses.
Which ones are the child seat tether points?
 
.
 
Last edited:
Which ones are the child seat tether points?

Actually now that I think about it, I must have randomly picked a point behind the 2nd row and drilled a hole. Then installed a backing washer and a race harness eye bolt to use as a child seat anchor point for my kids. Before that, I used the 3rd row floor mounting bracket to anchor the child seat. If I remember correctly, there's flat spots suitable in the rear floor for child seat anchors. This was a long time ago. Sorry for the confusion.
 
Back
Top Bottom