ABS activating on every stop - why?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 27, 2003
Threads
161
Messages
3,051
Location
Holland, Michigan
At every stop, my ABS activates just before coming to a stop. It happens at around 2 or 3 mph, activates for just 1/4 to 1/2 second. I get the ABS sound, the pedal drops slightly and vibrates, it sure feels like ABS activating. It happens on wet pavement (there is no dry pavement), at mild braking, I'm sure there's no skidding happening. No work has been done on the truck in months (oddly). No abuse or off-roading has happened (sadly). Temps have been in the single digits at night, not much higher in the days, streets are mostly snow-covered. ABS appears to work normally on slippery stops. It's been happening for a week or two, getting gradually more consistent.

This is a '97, 170k, no mods, 100-series front pads, birfs done several years ago.

Could ice on a sensor or ring cause this?
 
I'm thinking more likely a frozen caliper or warped disc is putting resistance on one wheel causing it to stop quicker than the others. Have you checked the pad wear?
 
I'm thinking more likely a frozen caliper or warped disc is putting resistance on one wheel causing it to stop quicker than the others. Have you checked the pad wear?
Hmm, it stops smoothly and normally, I'd think I'd notice one wheel skidding. I'll take a look anyway, thanks for the suggestion.
 
I'd think it's with the exciter rings or a sensor. Just need to start pulling and cleaning.

I'd start with the sensors then move to the rear rings and then finally the front rings.
If debris is a possibility, it's likely frozen debris. It's supposed to get up near freezing end of next week, perhaps that'll cure it. Or maybe I'll try running through the car wash and get the extra underbody flush and wheel blast. Thanks.
 
You could also back probe the wheel speed sensors connector (with a volt meter) at the ABS ECU and monitor the voltage for each wheel speed sensor ( you will only be able to do that one at a time unless you have multiple volt meters).

Then you could determine which wheel speed sensor is "slower" than the rest and go to that sensor to either clean or replace.
 
It seems to have healed itself. It was still happening consistently on my drive up to Boyne this weekend, but I didn't notice it the next day in Petosky, or today driving back and running errands. 500 miles on mostly wet pavement, perhaps it cleared itself somehow? I don't want to end up like that other guy who broke his sensor trying to get it out to clean it:mad: . I had both fronts out a few years ago doing the birfs, hopefully my extra efforts then will help them come out if I have to.
 
You probably have metallic debris stuck to the tip of the sensor (magnetic) that is causing erroneous feedback to the ABS computer. It's easy to clean, just undo simple hardware and pull the sensor out.

Good luck.
 
That happened to mine a few times...but only because I was stopping fast and usually on a slight downhill.

I have a lift and haven't adjusted the LSPV yet...I just figured I was stopping a huge beast of a vehicle faster than it wanted to.
 
Agree it will likely be debris on a sensor. I'd pull the sensors and wipe them off. It's a simple thing. Be gentle with the wires - especially with cold temps. Of course check your tire pressures as well as that could add to the sensitivity of the system if one's off.

DougM
 
Back
Top Bottom