a442f transmition problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 10, 2014
Threads
3
Messages
17
Location
Barcelona, Venezuela
Website
www.imacvenezuela.com
1456016_10152000375059819_742475003_n.jpg


Hello people, I am Diego Colonnello From Venezuela..... in the picture i present to you my 80.....

i am writting because i have been reading a lot in the forum and i cant find someone with the same problem...

I am sure that some one can give me a little help on this...

My car has the automatic transmition and it has a problem when shiftinh from 2nd to 3rd.... up or down..... when shifting it has a delay before locking the next gear and the engine revs up a little depending on how much i am acelerating..... it does not slip any gear...... only problem is between those gears..... overdrive works good and other funcitions are awesome....

i hope you can help...
 
I had a similar problem with shifting at partial throttle. Tightening up the transmission kickdown cable, and changing the ATF fixed the problem for me.
 
Hi Diego,

What your describing is know as "flare" between shifts. It can be caused by many different things, but the most common is contamination of clutch material or steel in the valve body hydraulic circuits. Many times this can be fixed by doing what's known as a passive flush of the tranny and all new fluid and filter. Another good way to test this is to do a test under heavy acceleration with the throttle more than 3/4 depressed and see if the shift still "flares" between the gears. If it doesn't flare, then contamination is one of the more likely culprits of this problem. The added line pressure during heavy acceleration forces the shift through the pattern and overcomes the blockage from the contamination.

Also, if it occurs during manual shifting through the gears, then the solenoids are not the problem. They are not used during manual shifting.

How many miles on the transmission and how long since the last fluid and filter change?

Don
 
Tightening the kickdown cable solved it for me too. It had a slight rpm rise and delay between gears before. Now that's gone.
 
I would certainly check the TV/kickdown cable for proper adjustment. But if you tighten it and start downshifting at 1/2 to 5/8 throttle, then you know you have it too tight and are just covering up the real problem by increasing line pressure with the TV cable.
I'm not saying that tightening it won't fix the problem, but you do have to ask why is it only happening in one gear? If the TV cable was loose to the point it allows slippage upon shifting, then why doesn't it happen in the other gears. Just food for thought.

I would still like to know some history on this tranny like how many miles it has and service history.

Don
 
I would certainly check the TV/kickdown cable for proper adjustment. But if you tighten it and start downshifting at 1/2 to 5/8 throttle, then you know you have it too tight and are just covering up the real problem by increasing line pressure with the TV cable.
I'm not saying that tightening it won't fix the problem, but you do have to ask why is it only happening in one gear? If the TV cable was loose to the point it allows slippage upon shifting, then why doesn't it happen in the other gears. Just food for thought.

How long have you been hanging in the 80's section?

Flare between 2-3 (only) on the A440F/A442F due to kickdown cable stretching over time is a *very* common and easily corrected issue.
 
Back
Top Bottom