A/C and PS pulley requirements

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 3, 2019
Threads
59
Messages
186
Location
Ohio
I have a 74 that I want to do a PS conversion for and possibly an A/C in the future. I understand that most of these set ups require an upgrade to the water pump and crank pulleys. Here is my current pulley set up:

IMG_3533.webp



For PS I am thinking: Power Steering
For A/C I am thinking: FJ40 AIR CONDITIONER, F&2F ENGINE

Would I be able to do both of these upgrades with just an upgrade to the 2 groove crankshaft pulley to something like this: 2F or F upgrade 2 wide Groove Crankshaft Pulley 1975-1987 [13470-60120 -U] - $245.00 : CruiserParts.net, Toyota Landcruiser Parts
 
I don't think that will work. I believe you must have a 3 groove (2 small/1 large) crankshaft pulley. I may be wrong but that is what I have been operating under as I plan my upgrades.
 
Perfect. Exactly what I was looking for. I have an F engine, I take it the 2F pulleys would fit the F as well. Would this mean the water pump pulley needs to have 3 grooves too?
 
We are using a double pulley and have power steering on drivers side and AC and Alt on passenger side. Water pump/fan clearance and having the correct holes in the block might be an issue. Georg at Valley Hybrids, Cruiser Outfitters are decent resources and we purchased the Vintage Air kit from Cruiser Corp.

4A98D055-52CF-4567-88FB-B734A4B92909.webp


AA542ADD-B602-474F-8D66-C504CF6C0D9C.webp
 
Using non OEM parts may be the difference. Less expensive that for sure. I have not seen it done like that. Could have saved myself several hundred dollars if it would work using a OEM PS pump mounted high. Crap.
 
We are using a double pulley and have power steering on drivers side and AC and Alt on passenger side. Water pump/fan clearance and having the correct holes in the block might be an issue. Georg at Valley Hybrids, Cruiser Outfitters are decent resources and we purchased the Vintage Air kit from Cruiser Corp.

View attachment 2057427

View attachment 2057428
Do you have an F or 2F?
 
Using non OEM parts may be the difference. Less expensive that for sure. I have not seen it done like that. Could have saved myself several hundred dollars if it would work using a OEM PS pump mounted high. Crap.

The Saginaw pump low is to be able to use my F air cleaner. An oem pump in the upper position would work as well. The Alt and Ac are in the Vintage Air bracket that is available outside of their kit.
 
Back
Top Bottom