- Thread starter
- #41
Tried my hand at painting the inner door jams, just so I can fit the doors already. Did the hinges and some bits and pieces.
Plastic wire loom covers and heating vents were resprayed, as well as the backseat heater. Applied butyl sound deadening on the floor to cover around 40-50% of surface as recommended. Debating on putting a layer of MLV over it before carpet. Extra attention went to the transmission tunnel and the wheel wells. Inside rear quarter panels done as well. Inside of doors also. Doing hollow section wax for the doors and quarter panels tomorrow.
Plastic wire loom covers and heating vents were resprayed, as well as the backseat heater. Applied butyl sound deadening on the floor to cover around 40-50% of surface as recommended. Debating on putting a layer of MLV over it before carpet. Extra attention went to the transmission tunnel and the wheel wells. Inside rear quarter panels done as well. Inside of doors also. Doing hollow section wax for the doors and quarter panels tomorrow.