9" ring gear in Landcruiser diff?

[T1000]

Hi all,

Newb to these forums, I hear they're the place to go for Landcruiser tech.

Here's my question:

Are there, or are there not, certain models of Landcruisers that had 9 or 9.5" ring gears?

 

[dgangle]

...prolly have more luck with a meaningfull response if you posted in one or more of the Land Cruiser sections instead of the Toyota Truck Tech.

 

[4rnr]

Hi all,

Newb to these forums, I hear they're the place to go for Landcruiser tech.

Here's my question:

Are there, or are there not, certain models of Landcruisers that had 9 or 9.5" ring gears?

yes..

 

[WristPin]

figure out what series of cruizer yer tryin to figure out and find that section and ask.

i know a little bit about the trucks but not much at all about cruizers...



(how did i end up on this site?? )

 

[KLF]

i know a little bit about the trucks...

Well, stick with us. Hopefully someday you'll know as much as Hilux...

 

[WristPin]

LL
dont put that curse on me!

 

[T1000]

...prolly have more luck with a meaningfull response if you posted in one or more of the Land Cruiser sections instead of the Toyota Truck Tech.

That's why I asked here, I have no idea which ones would have had them....

 

[Hypoid]

I think the 80s had a 9" in the rear.

 

[knixen]

the 40s/50s/60s/BJ&HDJ70s/80s rear have all 9,5" diffs, so all most every cruiser...

 

[T1000]

What about the fronts?

 

[cavemancaleb]

8" high oinion on the 80's, not sure about 60's or 40's. one of the other cruiser forums should know, maybee ask the 60 guys

 

[RockDoc]

Front diffs till 90 are essentially the same as the rear. (asside from semi float vs. full float differences)

 

[T1000]

So that's a 8" ring gear?

 

[RockDoc]

No, 8.8 or 9.5 or what ever. It was with the introduction of the 80 series in 90 that they went to a smaller front diff.

 

[cruiser88]

oh dear jesus

Well, stick with us. Hopefully someday you'll know as much as Hilux...

 

[T1000]

oh dear jesus

Is this information just all wrong or what? If so, please let me know. I'm trying my best to get this all figured out.

 

[RockDoc]

He's replying to what he quoted from KLF.

 

[knixen]

the 40s/50s/60s/BJ&HDJ70s front have all 9,5" diffs, so all most every cruiser...

this is not rocket science, read a little and check the different series techs... then you wont have to ask so much and looking to say the least lazy! Good thing this is not pirate...

 

[T1000]

the 40s/50s/60s/BJ&HDJ70s front have all 9,5" diffs, so all most every cruiser...

this is not rocket science, read a little and check the different series techs... then you wont have to ask so much and looking to say the least lazy! Good thing this is not pirate...

Sorry...Yeah I can't but take a shortcut every once in a while...trust me, I've done plenty of research for my plans already...

 

[4rnr]

I cant beleive this has gone on for 20 posts on a "landcruiser board"

9.5" rears in all of em, and 9.5 fronts in all of em, except the 80. That had a HP 8"

As far as I know....