78' Tranny question...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Most of these GM SM420 and SM465, are cast iron.

toyota cases should be aluminum... I pretty sure of this. It's been a while since I've looked at mine.
 
F-junker said:
Most of these GM SM420 and SM465, are cast iron.

toyota cases should be aluminum... I pretty sure of this. It's been a while since I've looked at mine.

Nope.

THe 3spd tranny found in cruisers up to '74 and the 4 spd (H42) tranny found in cruisers from 74 on were definatly not aluminum.

The SM420 and SM465 are cast, and are both GM trannies. SM420 '47-67, SM465 '67-8?

SM420/465 can both be adapted to the F and 2F engines, and to the 3 spd transfer case with a simple plate adapter. This conversion is often performed to gain the very low first gear of these trannies. top gear ratio is the same for all 4 transmissions.
 
Post up a pic from the bottom....



do you use first gear on the street, or do you drive your four speed like a three speed?
 
350-78LandCruiser said:
OK so how do I tell what I have on my 78 with a Chevy 350? This is my frist fj40 so I'm still kind of new to all this stuff.

Todd
Chandler, AZ

Take some pictures and post them up or google sm420, sm465 and H42 transmission and look at the pictures. The search button might turn up some pictures too.
 
I have a four speed but drive it like a three speed. 1 is to dam slow. Plus I have a 4-10 in the rear. Not sure what that does for me but I know it was set up for rock crawling.
 
Back
Top Bottom