64 brakes

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 26, 2005
Threads
44
Messages
203
where is the bleed valve on my brakes???

the brakes havnt worked since i started working on the cruiser... i checked the brake cylinder to find that it was completely dry... the pedal has no resistance at all... i filled up and pumped the brakes for a while just to see if there was any difference to no avail... i know i need to bleed out the brakes and i know i can do it ....

can u guys just tell me how... i checked the tech links, but the only link doesnt work ...

anyone got a pic of the valve or whatever i need to bleed the brake line???


thanks


Blake
 
You have to start on the furthest wheel out. Each wheel there is a bleed nipple

Time to get a serice manual too. It'll walk you though the simple things like this and if you plan on keeping this beast it'll be well worth it. I'm sure some will chime in on tricks of the 4 wheel drum :)
 
Sometimes the bleeders break off. :doh:
 
There are other sources.;)
 
Anyway, the bleeders you want are on the inside (backside) of each brake drum. You need to look for them a little if there's a lot of dirt, muck there, and you'll be pretty happy with your foresight in buying a METRIC brake bleeder wrench (Napa, Harbor Freight, etc.) before you start.

Be slow and careful. Get up and refill the master cylinder after bleeding each wheel - it might take quite a bit of fluid because flushing it all out will be a good thing to do. Get a quart of DOT 3 fluid.

Look for leaks everywhere. You've got a single reservoir master cylinder system and that means that leaks front or rear can leave you with no brakes at all.
 
honk said:
...and you'll be pretty happy with your foresight in buying a METRIC brake bleeder wrench (Napa, Harbor Freight, etc.) before you start.



While a metric line wrench is something you will want to pick up for use on brake lines in the future, a six point deep socket fits just fine and works considerably better at breaking the bleeder screws loose.



Good luck!


-Steve
 
that set up had banjo fittings at each cylinder, right?
Check those carefully. I had one let go (from rust and corrsion) while on the trail on my 67, and with a single cyl master...that sent me rocketing backwards with no brakes at all.

They are available new from the dealer if ANY of them look bad.

Good luck.

Your brake line fittings are an odd size as well. Just FYI.
 
Back
Top Bottom