2f timing and carb adjust

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I have tried and I have all but givin up, was hoping there is some one close to Dallas that I could take the 40 to.
 
I have tried and I have all but givin up, was hoping there is some one close to Dallas that I could take the 40 to.


You need to learn how to do this. Read the manual and practice, take lessons and practice or read about it here and practice. You'll also need to learn how to adjust your valves...
 
Just adjust idle richness to get best idle at idle speed after warmed up and driven. turn speed 600-700 rpm. Anybody with light that can adust timing can do LC-or get cheap light and do it. after set mark dist and maybe play with advancing it slightly. If you have lots of other problems they need to be fixed first-carb internal problems-vac leaks-vac advance diaphragm-centrifugal adv stuck-etc.
 
I would advise the vacuum gauge is essential---my .02
 
You can!

Do a Search on the Lean Drop Method and start reading. You will need a screw driver and a timing light.

Not very difficult...

BTW, welcome to MUD!

I'm getting ready to tune my carb. it runs OK, but timing seems to have to be adjusted beyond where it should be to account for what I believe is a rich running carb.
 
Should you find local to someone to assist please have them teach you how to do it.
Valves, carb, timing. DIY is very satisfying.
Buy a vacuum gauge and read the threads on mud about all of the above.
 
I'm getting ready to tune my carb. it runs OK, but timing seems to have to be adjusted beyond where it should be to account for what I believe is a rich running carb.
They go hand in hand. Do them together. You might have to do several times to get it dialed in.
The first time I did it I adjusted the carb and timing 3 or four times using a vacuum gauge after adjusting the valves.
Played around with the lean drop method and max vacuum method
The timing is often needs to be advanced to 9 or 10 degrees BTDC on a desmogged 2F.
 
Back
Top Bottom