2F TBI Mileage?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 13, 2003
Threads
33
Messages
156
I am looking into a TBI conversion for my FJ40. I was wondering if any of you have before and after experience. Something where you have a reasonably scientific calculation for your fuel mileage improvement. I think that the driveability alone would be worth alot, but some increase in efficiency would help.

Experiences anyone? How about experience with other EFI swaps and their improvements?

Thanks as always, ROB
 
I have heard you have to siphon off the excess fuel after each outing.....
 
Now that's what I'm talking about! Better to have more when I get home than when I left.
 
ToyotaJeep said:
Now that's what I'm talking about! Better to have more when I get home than when I left.

From what I have seen about the TBI swaps, you aren't really going to gain much in the way of mpgs. A properly set up AIsin carb will get you 15-16 mpg. which I get that pretty consistantly.(I run 35" mud terrains, 4.11 gearing a healthy 2F, and an SM420).

THe only reason I am doing TBI is for better off camber running, and because it's a stepping stone for a few other projects I am working on at this time... :D
 
I used to get 10 mpg with my '76 TBI'd 2F in an FJ40. 10 loaded, 10 empty, 10 towing a trailer, 10 with 33's, 10 with 36's....you get the idea. I pulled it in favor of a JimC carb and still got 10 mpg. :mad: This is with an HEI ignition set to stock advance, header and decent exhaust system. Highway, city didn't matter; 10 mpg... Had an O2 sensor with the TBI but no timing control or speed sensor. I figure the lack of a speed sensor was a part of the mpg issue.

Gotta admit it was great on the trail! Laid the truck on the drivers side and it kept on running. Had to shut it off before something bad happened to the motor. The TBI system I had was also one of the first put together by Up & Over Innovations (they no longer sell this conversion). I figure the chip needed a few more tweeks to be fully "right" so I would have received all the benefits of TBI.

I was happy enough with the potential of the system to collect the parts to try again on one of my other rigs. This time I'll deal with the programing myself and with the help of a few local guys running similar set-ups.

HTH,
Nick Jennings
 
Ok that is fair enough. I did build a nice 40 about 3 years ago with a crate 350, performer, and a good Quadrajet that got around 12MPG. It was sprung over with 35's and an SM420.

With my current rig, I am looking towards a 420/465 swap, soa, and 37" tires. I would love to get in the mid teens, but I may be a bit optimistic.

I like the idea of 14-18 mpg. With a daily commute of approximately 40 miles, the difference between 9 and 16 is rather significant.

I appreciate your reply, ROB
 
I think you're right. That must be the reason why so many convert to the 350. I know what mine got, and it was the same basic combo I am looking at now.

I would imagine a good running tbi on a 350 would probably pick up 1-2 mpg over my previous 12ish, which would put me where I feel I need to be.

The other engine I have been looking into is the 300 6 Ford. I don't hear much about them being swapped into Cruisers, but I would imagine that they would make a pretty sweet set-up.

Something to think about......
 
The only 40 series trucks I hear getting the kind of mileage your talking about are the BJ40's. Those who own BJ40's with a 5-sp regularly report mpg in the mid to high 20's... MPG is more than just the motor. Having OD and high diff gearing are probably more important than the motor.

Nick
 
Personally I doubt that you would see any significant fuel economy improvement with either TBI or a 350 swap. Maybe .1 or .2 MPG. The reason is because there isn't a significant difference in the efficiency of the engines. OTOH, a diesel is a more efficient engine. It burns a fuel with higher energy content per volume and it has a higher thermal efficiency.

The reason for poor fuel economy is fundamental physics:

Force = mass X acceleration. Cruisers are heavy beasts with the aerodynamics of a brick and fiddling with which engine isn't going to change the fudamentals.
 
guys go out and get a 1bbl carb i get about 14 mpg on the way up to the top of the grapevine from my house in costa mesa about 100mi, and this was when i was running late and hade to stay in the carb the whole way up there... ie 65+ even up the hill.
 
Bennett said:
Someday if I ever finish it .. I will finish my port injection on a 2F.. I think TPI will yield a better result in miles per gallon . I think a wet intake on a TBI or carb is less efficient than a individual port injection. I will run a Megasquirt ECU .
I am stumped on the fuel rail at the moment. I wanted to make soemthing a litttle more sano than this guy did.
I also think 3.73 gears will help as much as anything in a fj40 as a dd striving for better economy.

pic of port injection on a F motor..


Bennett, Are you the guy up in Walden from the Yahoo LandCruiser EFI group?
 
I put on the TBI and my milage never really changed. A little bit better, but not very noticable. Better power though. My speed sensor is not hooked up though. I am getting an adapter made to put the VSS on. Toyota discontinued the shorty speedo cable. I hope it is here soon, I'll let you know what kind of difference it makes.
 
For all you folks not reading the LCML, this guy just finished an MPI design (is it you Bennett?)

http://www.birfield.com/modules.php...hives/html/landcruisers/2005-03/msg01157.html

manifold_preview_1.jpg
 
i dont know if it relates, but on my SBC 350 i got about 10 with the carb. and i recently got 13 with my new TBI motor (sb 350) that 13 is on a trip from Colorado Springs, to Moab.. so better, but still not great... i bet a Perfectly tuned carb would get the same sort of figures..
 
Back
Top Bottom