2f Smoking

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 23, 2004
Threads
14
Messages
83
Location
Savannah, GA Area
My 2f has recently started smoking, burning oil, on deceleration. Compression numbers are around 125 on all cylinders. pcv is fairly new. what's next? valve seals?

It does not smoke on acceleration. just if you rev it and let off it will and when letting off completely when slowing down. if i baby it when slowing i don't get any smoke.

Thanks for any suggestions

R.C.

2f, stock carb and manifold.
 
Not to hijack this thread too much, but my 2F ('78 40) is also smoking the same way.

Haven't tried the SeaFoam yet, but was told if you do a compression check before and after squirting some motor oil into the plug holes, the cylinders with bad rings will show a substantially higher compression reading right after the oil is inserted.

Fact or BS?? :confused:

Anyway, I tried that on all 6 and read 120 across the board before squirting in oil. But, cylinders 2 & 6 jumped up to 145-150 after the oil insertion. (1, 3, 4 & 5 stayed at 120.)
 
Could also be stuck rings. It would show the same symptoms. I'd seafoam before I ever ripped into the head. $8 is nothing compared to what ripping into the head might cost.
 
suck it through the pcv valve hose. That way it will hit all cylinders. Same principle as shooting up I guess....
 
I'm probably waay out on a limb here, but I had a '68 MGB that all of a sudden started to do that exact same thing. It turned out to be something in the smog system called a "gulp" valve. $15 fixed the thing. I have a '66 FJ40 with a '74 motor and absolutely no smog stuff, so I really don't know what I'm talking about. But does the air injection pump and all its plumbing have any sort of check valve, I mean besides the PCV?
I am a huge believer in SeaFoam, but have never used it in anything but the tank.

GL

Ed
 
Another potential culprit could be pulling oil by the valve stems. On sharp decel, you're creating a large vacuum in the cylinder which will tend to pull the oil down the valve stems if the seals are getting hard or cracked. I've seen some valve stem seals that were more like umbrella's or hats versus a complete seal to the stem. They might be more likely to behave this way also.

Just my $0.02

Jeff
 
Back
Top Bottom