1fze head bolt thread pitch?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

There are thread chasers made specifically for your intended purpose. These are not taps and will not remove any parent material.
 
Yes. I borrowed an entire set from a buddy.
 
I am seeing these in fine and coarse. I imagine coarse "cuts" a little deeper and bigger thread. If that is correct i would thing fine would be safer in removing less materiel. Is that correct?
 
I can't say for sure because I learned of this tool here on mud less than one year ago. And as I said earlier, I asked a buddy if he had some I could borrow and it happened that he did but I don't remember anything about fine or coarse. I would think that it's either the correct size and pitch or it's not.
My suggestion is to return those bolts and buy the studs from Paradiseracing.com. This will remove any doubts about the quality of your torque job. The full set was under $200.
 
Whoa! this must be fairly recent that ARP now offers a specific set for the 1FZ-Fe. Very cool. 1FZ-FE ARP Head Stud Kit - Paradise Racing
I don't think too recent actually. You will hear many members say they think the studs in this kit are not long enough because they don't bottom out without being too short. That's nonsense. I spoke to an arp engineer about this and he told me a stud need not bottom out as long as it is installed like twice its own diameter. Mine went in 16 turns and left two threads protruding above the nut. they torqued down well for me and now, one year later, no problems.
 
Arp thread Chaser for that size will set you back major cash their are other options available cheaper.I got mine from jegs still expensive.jcardona1 got one much cheaper he listed the site on one of his posts.but what is peace of mind worth to you.plus it doesn't remove metal and you will be surprised how much gunk comes out of the holes where the head gasket failed.use compressed air and brake clean to get as much as possible of the trash out.
 
Back
Top Bottom