1962 Fj40

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 22, 2006
Threads
19
Messages
103
Location
Blue Ash Ohio
I picked up a 62 FJ40 in SoCal this past week..its been in SoCal its entire life so it has very little rust :D its been in storage for the past 20 years with no engine in it. Now what engine should I put in it ? can't wait to get started on it...
 
Last edited:
Ok time for my usual song and dance:

Stock! (preferably F135)
or Stock Diesel! (B)

Song and dance over.
 
For as much as I like the F135s in my 64 and 65, and just drove the 64 3600 miles without incident across the country, unless you're planning a resto, you might as well just go with whatever F or 2F you can find in good condition near you.

The transmission is actually more critical than the engine, and as long as you're not going resto, get a 4speed.

You've listed your location as OH. You might want to give Jim C. over at TLC Performance a call to see if he knows of a good motor nearby. He's also in OH.;)
 
if you're a purist, the f135 or whatever it would have come with, but if you have this sweet clean slate,I would say diesel, screw it, you're probably going to have to do a bunch of work to get any non stock motor in there, might as well be one that is going to last for a long, long time. (and run cheap)
 
it depends

Welcome to Mud. And the Cruiser obsession.:D

It depends on what you want to do.

For a restoration, it would have to be an early F.:doh:

For a driver, I would recommend finding a rusted out 78-newer FJ40/55 (not too difficult in Ohio), and swap in all the upgrades:
2F engine
4speed
direct shift t-case
power dual circuit brakes w/ 10mm lines
Complete front disc axle assembly w/ fine-spline birfs
complete rear axle w. fine spline side gears & pinion
upgrade to rear disc, unless axle is 1981-newer
alternator
electronic ignition
Functional heater/defroster system
keep the retro-cool early column & 20" wheel, but add Mini PS upgrade.

I just missed a $500 FJ60 in Columbus last week.:mad:

Keep your eyes & ears open, they still surface occasionally.
 
Well it's NOT going to get a small block Chevy put in it...:ban: It's going to get some type of Toyota engine more than likely a 1UZ with a Turbo 400 trans...I have access to a Toyota Marine 1UZ that is brand new in a crate ECU and all...the Marine version is a 300 HP VVTI engine :eek: I will get the mounts fabed up and then pull the FJ all apart and get the frame powder coated and do it up right but I will leave the body stock should be a cool 1962 FJ40 when I'm done with it.

Don

Note: see picture.. Grandfather and Grandson
 
Last edited:
Welcome.



The blue thing is a Toyota....but it is the furthest thing from a Land Cruiser.


Nice 40.


Good luck with you swap and rebuild. I will be very interested in watching this build.


:beer:
 
nice score X2

and please keep us posted on the biuld, sounds interesting. i am a chevy guy but that combo (1UZ & turbo 400) would be nice in an old cruiser! :beer:
 
nice 62 oh yeah and nice FJ as well. lol

look great together good find!
 
THAT green BEZEL boy .........sure looks familiar just like the one on my 71 40.........last seen on highway 50 in NEVADA:frown: , cool rig I like the OLD SCHOOL hard top keep it TOYOTA :cool: JC
 
I will post picture as my project moves forward.. As for the new FJ Cruiser its not mine its a training vehicle from work.

Don
 
No engine? Go diesel! How about a 13BT for that? :)
 
Toy Teacher said:
As for the new FJ Cruiser its not mine its a training vehicle from work.
Uh?? Explain please. :confused:


BTW, hop on over to the FJ25 Forum every now and then. Lot's of early 40 owners hanging there for similar parts, ideas, etc.
 
He must work at the Toyota Motors tech center in Cincinatti.
Along w/ TLCA administrator Metalspice (Jennifer Lorincz).

We have 2 people on the inside now. It's only a matter of time until we start getting the HZJ75's imported! :cool:
 
Back
Top Bottom