***All sold locally***
I'm stationed in Okinawa and these will ship via USPS, prefer CONUS but will consider international as well.
Greetings. I just removed these from my 1994 KZJ78W, but I beleive they should fit on any 70 series rear bumper as they are the same (someone please correct me if...
I think my next move is probably a 2" lift rather than skids for a few reasons. The truck just passed 289k, the shocks appear to be original, I've installed the Ironman drawer system (awesome), and a little room and stiffness are very much in order. After this I'm thinking rear bumper before...
After cutting out the OEM shocks, then removing the stock springs I can't now get the replacement springs to fit. I have removed the rear drop links, disconnected the rear sway bar but still can't get enough room to install the new rear springs. I am going stock 105 rear springs with no lift...
Noob question but there is enough room for me to work under the vehicle without raising it but I was wondering from a load perspective if it's necessary to jack up the vehicle to install a diff drop?
As the title suggests. Do you think next year with the introduction of the new “Land Cruiser” Prado to the states that the prices of the LC200 will drop? In the process/looking at 2019 Land Cruiser’s and wonder if I should pull the trigger now or just wait till next year? Saw a couple of 2018’s...
Hey I noticed when parking at full lock, at a weird angle on a hill today that my Tire looked super weird, off camber a lot etc.
Anyway I looked inside and saw the CV looked like it was popping out, and there's also a leak or something.
Planning to replace the CV probably, but wondering if I...
I have looked on the internet and this site and can’t seem to find a website that I can order a front and rear drop in third members for my 95 fj80 with 5.29 gears and selectable locker
Does anyone know if a website that will let me just order that and ship it to the house?
Brand New unopened Dobinsons Front IFS Diff Drop Kit for Lexus GX470, Toyota Tacoma 4Runner and FJ Cruiser.
Kit #: DD59-527K
Keeps CV angles at a good working angle
Allows for lifts over 2.0"
Includes all necessary hardware, including machined spacers and nuts/bolts
Compliments Dobinsons 3"...
I am a vocational teacher at a high school in Wyoming, and we are looking into making an off road tear drop trailer as a school project. I have seen professional ones sell for $15,000. And I have seen homemade ones sell for $2,500 on craigslist. My tentative plan was to try building one for...
Hypothetically, if I was running a stock CT26 turbo at 11psi measured at the manifold and fitted an intercooler I would likely see a pressure drop if u measured boost at the same point.
Let's say this drop is 3psi. My boost is now 8psi. If I use a boost controller to increase this back to my...
I am going to be installing some MAF drop brackets in the next couple of days and was curious if there are and tricks/tips to doing so before I get started. Is there a certain technique to use to lower the rear of the LCA? I have also heard mention of some grinding to aid the install - where...
I have finally pieced together the parts for my lift (850, 860) and am just missing the means to correct caster to complete the install. I don't like the CC bushing idea, so looking for either the control arm drop bracket (DD and fire road use, no rock crawling) or caster correction plates that...
Right after the engine starts, it drops RPMs and then goes back up again and idles fine. I've only noticed it recently, haven't done much that I suspect would have caused it.
Any ideas on what could be the issue? Tried searching but didn't find anything. Thanks everyone