Recent content by ZooKeeper

Yeah, I tried going this route, but the angle is the wrong direction & prefer to have arms that set horizontal with the top of windshield.

I was hoping you would respond Jim. What is the ebay number for the bracket? I have not done the baffle/chimney yet, but it's on the to-do list. Thanks for your response.

01/1973 FJ40 F with Holley 350 The PO had cut what looks like an original accelerator cable but many of the wires had rusted/broke & it was a sloppy application (spring hooked to brake line). In searching on here, the interwebs, & manuals I have been unable to run across a good solution to...

My traffic to the forum is way down since tapatalk went down. Kind of bummed about this.

Thanks for the quick reply FJ40Jim, I'll add it to the list! Sent from my iPhone

I decided to change the oil in the diffs, transmission, & transfer today. The rear seal in the transfer has been leaking & the parking brake hasn't been holding so I thought I would change the seal & put new pads on the brake. This is a 01/73 FJ40 with a 4-speed transmission I bought in July &...

What kind of MPG are you getting on the hwy? Beautiful truck.

I'm in the process of figuring out which direction I am going to go on this...can you attach a carrier/roof rack to this type of gutter? Doesn't seem like you would which would be a big draw back.

Nice...what app is that?

Looks good...where did you get the bolt kit?

The ones that con-ferr used to make that ran along the wheel wells but didn't obstruct the bench seat.

Tuffy has the console mastered IMO. Can you focus on making a con-ferr style tool boxes for the back?

I have ordered these & picking up from the mainland next week. Based on their measurements, they should fit...the current NAPA's don't on a 01/1973 AdventureRV.NET 2 x Gas Spring 50Lb 17" Ext 10.25" Comp W/Plastic Ends (S117-311382) = $21.58

Awesome...looking forward to the reaction from the PO when you pull up...

Refreshing an old thread... The previous number listed isn't available any more. I went with the BA9S-WHP (25 lm) without tabs removed and pretty happy with the results. I think this would look pretty good as well with the tabs removed if you like a little brighter. @primer7, thanks for the...