Ok thanks. I don't see any leaks and definitely no warning lights yet. I'm having trouble uploading the short video of the ON position motor noise and bubbles in my MC reservoir when the brakes are applied.
Hey not to revive the bad juju but i think i may be having problems with the MC/Brake booster. Initially had soft pedal with slight sticking of pedal at top when starting in the morning. Softness was remedied by new front pads/rotors and brake bleed. Ever since brake bleed pedal has been getting...
Ok will add signature. Don't know why i thought this was 200 forum! I think i googled it and saw that it was related but i guess I'm mistaken. Thanks for your help!
Ok great thanks I will get this done tomorrow morning. I did the 40 pumps test and fluid was definitely over max line. Didnt see fluid leaking anywhere but i will inspect more closely in the morning.
Bottom of truck looks like it just rolled off factory line. That said, i think it was a 2nd/3rd/4th vehicle and possibly got neglected. Hopefully this booster/mc isnt shot. Again, braking power is fine after new fronts and a brake bleed but these little gremlins are worrisome...
Ok i think I'll do that. Thanks for your reply.
The following thread describes a good amount of what I'm dealing with but i did the thing where you pump the brakes 40 times and my brake fluid level was definitely over the max:
https://forum.ih8mud.com/threads/brakes-overdue-write-up.1230968/...
Hello LC,
Unfortunately I think i recently bot a rig with this problem :-(
Florida owned single owner 57,000 miles but probably poorly maintained. Inside and out looked great. No rust, engine seems to run great but after 2-3 months of ownership I'm finding things that make me think it was...
Update here: the bubbles occur specifically when the pedal is released after pressing. The google ai powered response says that based on this one symptom alone, it's definitely a seal gone bad in the master cylinder and it all has to be replaced immediately.
My hunch is the bubbles in the...
Decided to look into this today...seems like most guys are comp sci majors with convoluted methods but finally found a guy on YouTube who made the techstream look doable
The abs motor buzzes briefly upon start up then after pressing the pedal which others say is annoying but normal, makes the whoosh/hiss sound on pedal press and on release too but it's brief and only associated with actuation of brake pedal (apparently also common occurrence on these trucks)...
Ok sounds good thanks for the advice. The thread linked below seems to have a pretty good summary of what to do and it echoes what everyone has shared here. Will report back:
https://forum.ih8mud.com/threads/what-is-the-brake-bleed-sequence-for-200.1049544/