Recent content by wanderer

  1. W

    302 intake questions

    howdy all any help on this would be greatly appreciated.I recently replaced a 74 302 with a 76 302 out of a mustang II. I put my original intake on the new motor intake was a 85 cobra intake aluminum 4 barrel set up. the motor doesnt seem quite right running wise. its missing and was making some...
  2. W

    c-4 tranny prob

    yes the tranny worked fine before, and no nothing got changed out off the trans. however, the flywheel on the new setup was smaller and the location of the starter was bout 1 in. below where the original location was, but i used the same bellhousing, flywheel, and starter as well as the tranny...
  3. W

    c-4 tranny prob

    Im a newby so of course:flipoff2: thanks to all and sorry if im doin this wrong- anywho here's the problem. iv got a 72 fj-40 that i just put a rebuilt 302 into. it had a 302 in it before, and had major problems. the trans is the same one as before. the motor seems to be in good working order...
  4. W

    cam questions

    Yeah-I was thinking of converting them over to the adjustable stud type, but ive got a set of 74 hydrolic heads that have a whole lot more bite to them that I am rebuilding soon (pressed in stud loosened up so Im gonna tap the heads) but even if I did switch wouldnt I still have the same...
  5. W

    cam questions

    no they are mechanical, and they are positive stop type. no rocker arm stud to adjust the nuts on, instead there is a bolt that screws into the pedestool.ive got the specs for the new camshaft, but not for the old one so that i can figure out what size pushrod to get.
  6. W

    cam questions

    ive got a question for anyone who might know. Ive got a 72 fj40 with a 302 in it. i replaced the cam and lifters in it, and am trying to set cold lash. the heads are 84 mechanical and i have 6.88something pushrods. I have alot of slop . like about 1/8 inch. or so ( no micrometer) i was told by a...
  7. W

    rings on no. one piston

    I was wondering if anyone out there knows if you can pull the no. one cylinder piston without removing the main crank on a 302. I was told it could be done, but im right there now, and it doesnt look possible to me. i dont really want to pull the entire crank out, nor the engine. had a valve...
  8. W

    rear main oil seal blown?

    hello, anyone out there know how i could tell if my main rear oil seal is blown or not without dropping the trans.ive got thew oil pan off, and the dust cover of the fltwheel exposeed and i would think that id see oil everywhere by now all over the fly wheel, but nothing. the truck is smokin up...
Back
Top Bottom