cam questions

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 25, 2006
Threads
5
Messages
8
ive got a question for anyone who might know. Ive got a 72 fj40 with a 302 in it. i replaced the cam and lifters in it, and am trying to set cold lash. the heads are 84 mechanical and i have 6.88something pushrods. I have alot of slop . like about 1/8 inch. or so ( no micrometer) i was told by a performance shop that the pushrod length should be the same- but the slop? i have already installed the new cam, and the old cam is a stock ford cam the only stamps on it are a (21) and a star,like the jewish star. is there any way i can find out if these are the same without taking the cam back out? and if they are the same, doesanyone have any ideas what im doing wrong to have so much slop?id appreciate it and thanks ahead of time for all the ford comments.:shotts:
 
no they are mechanical, and they are positive stop type. no rocker arm stud to adjust the nuts on, instead there is a bolt that screws into the pedestool.ive got the specs for the new camshaft, but not for the old one so that i can figure out what size pushrod to get.
 
Ford cylinder heads with pedestal mount type rocker arms can be easily converted to use adjustable style rocker arms by using a Crane Rocker Arm Stud Conversion Kit.
 
Yeah-I was thinking of converting them over to the adjustable stud type, but ive got a set of 74 hydrolic heads that have a whole lot more bite to them that I am rebuilding soon (pressed in stud loosened up so Im gonna tap the heads) but even if I did switch wouldnt I still have the same problem cause of the rockers?even tightened all the way down ive still got about 1/4 inch of air. The cam I put in is a melling cam I think its an RV cam or something.cam lft .281 int/.296 ex--vlv lft .450 int./.474 ex--.050 dur 204 int./214 ex. this cam stuff is pretty deep! dont totally understand all the numbers.Man Im a plumber! this is like reading japanese to me.but the cam is new not reground I measured the pedestal heigth on the two different heads and there is a considerable difference from the hydrolic and the mechanical so i guess im headin to the shop to get some longer pushrods again.This is my daily driver and i need er running yesterday, just wanted to make sure i wasnt doing something wrong, or messin something up. thanks for the responces guys Ill post the results when it happenes.thanks again ,sean:smokin:
 
Back
Top Bottom