Any chance you could elaborated on what you did to prevent hitting the glass? I've realized that after aiming mine, both projectors are just barely touching the outer glass, creating a small rub spot. I need to fix it before it becomes a real problem.
My suspicion at this point is a few factors combined: lots of "warm up" idling that causes condensation and possibly too much gunk in the passage ways of the catch can. Once I open the throttle up while driving it sucks in all the excess moisture and voila, frozen butterfly valve. I have removed...
I pulled the intake boot off and I found considerable water inside the throttle body. I also disconnected the hose on the valve cover next to the PCV that goes into the throttle body and it is filled with oil/water vapor milk shake. I don't think that hose should be pushing air from the valve...
Good morning everyone,
Temps are getting cold here in AK. This morning was -30 F. I had the cruiser's (94) block heater plugged in all night. I let it warm up for 10 mins before I started the drive to work. After 5 minutes of driving, my throttle became stuck open at about 3000 rpms. It would...
So you have 70k into it, and you won't get all that back. Doesn't make any sense to me to sell it. You have to just start driving the thing. I fail to see how you wouldn't be bothered by driving a brand new vehicle on salty roads. Fluid film it and enjoy. Everything on this planet rots away with...
Have this problem also, 55-62 Mph. I replace my throttle cable for different reasons, but a new throttle cable did not fix the CC for me. Partsouq shows the CC cable as discontinued for a 1994. Still trying to find a solution.