Recent content by VanSyncro

Now Both are discontinued and NLA

did you sell? didn't see pics

Nows the time to get it on the calendar! Helps to have an objective to get those winter builds done.

Sorry, only the bellhousing to mate to a 3b.

Includes Shift fork, slave cylinder and shift knob. I've had this for about 5 years and prior to my purchasing it I have been told it was rebuilt by JimC? with new bearings, seals and gaskets and still has zero miles. Located in Milwaukee, WI $2700

Well I don't do that much deep water either but I picked up the ARB knockoff from amazon: Actually I picked up 2 to get enough fittings to run all vents high up on the firewall. The only thing these things do is keep water from leaking into the axles/cases they are connected to. It won't "fix"...

I have one, but it comes with a whole rolling chassis! :mad: https://forum.ih8mud.com/threads/bj40-rolling-chassis.1005371/

Sure the rust is just surface other than around a few of the valve holes as they were previously run with tubes.

Yes, I'll drop them at any shipping depot within 25 miles. The weight with pallet and packing should be about 200# or roughly 35# each if shipped individually from Milwaukee.

I've received payment, SOLD.

Sorry for the delayed response, I've been traveling with limited internet and phone service. It looks like sold, I'll update by Saturday either way. Thanks for all the interest!

https://forum.ih8mud.com/threads/arb-3411040-80-series-bull-bar-new-bent-in-shipping.1218151/

it seems like it might have

Milwaukee

Just found these again! Bump