Recent content by Uglymud

Bought one! Really wish I wouldn't have sold my 94 as it was pretty clean, but this one should make a great play rig. Paint is rough, interior is so-so and it looks like it has an upper oil pan leak. Haven't bothered with any pictures of it yet, plans are tentatively the same as my old rig. Odd...

Thank you! I must just be blind.

Are these still in production? Had one on my last rig and would like to grab one for my new project. Couldn't see any on the website.

PM sent, clean rig!

Could you send some underside and under hood pictures?

Well got it together with some sockets, a diy press setup with a 6 ton bottle jack and throwing the bushings in the freezer for a few hours.

Well I managed to get them knocked out with an air hammer, just can't find a good tool to get them back in. If I could bum some time on a press with the drivers that would be awesome! Thanks!

Planning to delete the AHC on my girlfriends 99 LX470. Looking for non-ahc torsion bars and springs if anyone has some laying around. Thank you!

Glad you like it! That's a clean looking 80 you have there!

Well that'd be very generous!

Wanted: FJ80 Semi Float rear axle w/ 3rd member, figured I'd check here before I went to the junkyard. Selling: FJ80 ARB front bumper, corners have been chopped to fit an 80 with clearanced fenders. Might still have the off cuts hanging around SOLD FJ60 fuel tank: some rust, we started the...

I currently have 4" Dobinson Flexi coils, with 3 inches cut out of the front fenders and half shot bushings I can stuff 37s in the front. If you're willing to trim 3" will do fine. Planning to bite the bullet and 3 link the front soon.

I was able to fit the 20" in there, but I had enlarge the hole in my crossmember to pass my lines through. I also snagged a larger power steering reservoir and rebuilt the pump. Hydro assist is in the future....

Don't know how often it happens with shorter lifts, but my coil contacts the little flange around the bumpstops up front.

Old thread, but just passing along my experience. My OD button was not working turned out to be a bad pin in the connector in the driver side kick panel.