Recent content by troopyoverlander

Reminding items

Unfortunately, I sold my HDJ80. I have the following parts leftover. I would prefer to sell as package, but I'm open to offers. Toyota Genuine OEM LAND CRUISER 2007/01- Cap Sub-Assy, Dust 17703 - 17010: $45 Genuine Toyota Diesel Engine Oil Filter 90915-30002-8T OEM for 1HZ 1HD-T 1HD-FT: $45 (2...

A US citizen can drive a foreign plated vehicle into the US without any paperwork/TIP. Generally accepted practice is you can stay in the US for a year like this, but there is no actual law. It’s obviously a rare occurrence.

Not looking to do anything illegal. Sale will need to happen outside the US. Guatemala titles can be transferred electronically with a NIT number.

This vehicle is best for someone looking to travel the Pan American and Africa. It's easy to register in Guatemala as a foreigner.

It can’t. It’s just here temporarily

Toyota Land Cruiser HZJ78 2016 with 30,XXX miles Left Hand Drive 1HZ with 5 Speed Transmission The vehicle has Guatemalan plates. However, it is temporarily in New Jersey. If you are planning the Pan American, you will not find a better vehicle for the journey. This Troopy is in incredible...

It came off an LHD 76 series Land Cruiser V8 with only 12,000 KMs. The winch was never used. Complete package is $3,500. OEM Toyota winch bumper OEM Toyota winch mount plate OEM Toyota winch fairlead and mount plate OEM Toyota Aisin A1-1000 Winch OEM Toyota J76 winch wiring harness and relay

Anybody need the Troopy interior ceiling panels and 3 crossmembers? I saved them from when my pop top was installed. Now they are just taking up space.

slow progress is still progress.

I am very happy how this turned out. Finally got some to time to start working on the Troopy build again. For a part that will be completely covered this sure took a lot of work.

Yes, no problem. When I get home later

I'm getting closer to finishing the initial build. It has been a bit more challenging than expected, but I'm happy with the result so far. I have learned so much during this process and I'm looking to forward to build another one to utilize all the lessons I learned from this 1st build into the...

I assembled most the cabinets and drawers and I am very happy with the results. I am impressed that I only needed to trim 1 board out of 75. Designing the buildout on 3D software and cutting on a CNC machine was a 100% worth it. I will do a longer write up about the entire process soon. I have...

I appreciate the response. Your designs look great and probably very light. Never used the downstairs bed is ironic, because it was the most complicate part of my design. I had a long drawer out the back of my Jeep, which I always liked. I guess the one big difference was the trunk opened up so...