Recent content by Trail Teq

Thanks for showing me that! The photo in that thread was the one that was sent to me so that person must have seen that on here too. I will just direct them to your version as it looks really nice + I would not have even got to that request for quite a while! Hey Rob! Touge Nation is our...

Funny that, I was actually emailed that last weekend by someone! No dimensions given though, so if you don't mind measuring yours I can add it to the que. I have the equivalent diesel motor versions also in the que with dimensions ready + a whole heap of others that people helped supply...

I'm not an auto glazier but I have learnt a few tricks with 80 series windscreens in my time of owning them, having chased a leak or two myself. The below is advice from a glazier who used to work for Toyota in the 90's. Double check what type of sealant they are using. It should be a self...

I want to reproduce everything from every market. The goal is to have a complete reproduction catalogue. If you have good quality pictures of those labels please send them my way (and dimensions in mm are needed). I will do my own research on them too. Here is an example of one decal that we...

And some examples of the body stripe kits!

Hey 80 Series Owners! We’ve just launched on the Trail Teq site a comprehensive range of restoration vinyl decal products, including reproduction body / information decals and body stripe kits. Everything in this range is meticulously reproduced off original samples. We have more information...

That is correct. Most 80 series have about 85AH of battery available to them and this kit uses about 10 milliamps, so would take close to a year to drain.

Hey @Fj80oregon Glad to hear your problem was resolved and I am happy that my customer service helped out. I had not actually seen these comments but thank you for tagging me. Not what I wanted to be reading or replying to a day before going away on holiday but here we are. Hello again! In...

Amazing!

Pleaseeeee record some sound clips/ drive by clips of this exhaust setup. It looks amazing.

Check where the inner fender bolts to the firewall. There is a box mount there that has a hole in the top, and "drain holes" at the bottom. The drain holes aren't the lowest point, so the box fills up with water/sand/etc and it causes rust. The rusty area is behind the pedals / the same side on...

A few of my HDJ80 'Teq' from a recent trip earlier in January.

I've seen one in person and was really impressed by it. Here's a video of one in a 79 with some figures. Just bare in mind you'll need aftermarket ECU and a tune with the Bullet kit. It's a higher performing kit than the Magnuson but with that comes the need for engine management. The...

It's tricky the first time you do it but once you figure it out, it's not as hard as it sounds. If you follow my steps you should end up with a good result. I can't stress enough the need for the master cylinder to be bled and free of air though, as well as how important it is for the person on...

Before going and replacing anything, I would do a full bleed including the master cylinder. 1. Remove MC, and bench bleed it with one of the kits that feed the outlet ports back into the reservoir. Reinstall in car when finished making sure not to push the piston in or pump the brake pedal...