Recent content by tohox

So the new mirrors will fit the old mounts but the new mounts will not necessarily fit my old door profiles? The old 24V motors still work fine and I can manage the motor swap if they are mechanically compatible with the new mirrors. Thanks,

Hi Can anyone tell me if side view mirrors for the more modern HZJ76/GRJ76 (part numbers 87940-60C90 and 87910-60F00) could possibly fit the older PZJ77/HZJ77? If not, do you know of other currently available parts which would? I believe the part numbers for the original electric side view...

Hi, I've seen this mentioned a few times in different threads but to my knowledge no one has detailed the exact solution. So here goes. As soon as temperatures would drop below 0°C (32 F) my 1991 PZJ-77 would have a hard time starting. The colder it would get the worse the symptoms. Chuffing...

Hi, I'm in the process of dismantling/restoring/replacing the fuel tank, filler neck and various fuel related components on my 1991 PZJ77. I think I might have to replace the filler neck but that part is no longer available (77201-60360). There is also a very similar part for later models of...

So! driving around with the rear prop shaft removed made no difference at all but I did find the source of both the high speed noise and the low speed vibration+rattle! Turns out I had removed my roof top tent a few days ago and hadn't driven at highway speeds since removing it. With the tent...

When I first imported the truck I had to change a rear diff. seal after which I had a very hard time reinstalling the prop shaft as I couldn't extend or retract it. I brought it to a local shop and they noticed it was packed solid with grease. They managed to empty it with compressed air and...

Thanks for the feedback! I'll investigate further once the prop shaft is removed.

Hi, I've noticed a hum when coasting from highway speeds. The sound will often appear as soon as I depress the clutch but once it has started the hum will remain even if I release the clutch and but will disappear if I accelerate or slow down enough. The sound becomes a vibration and eventually...

Thanks for all your cues! I don't have access to any 4 cylinder LC radiator hoses for comparison unfortunately but will base my search on those, I'll post back if I find something compatible.

It is indeed used to loop the accelerator link back over the air intake on the LHD versions!

@FJ73Texas Aaaaah! Finally! Thanks so much!

Hi, The radiator inlet hose on my 1PZ has started cracking a bit and I'd like to replace it. The original part number is 16571-17030 but is no longer available. Does anyone know of a compatible replacement? Or could this kind of hose be purchased in bulk, cut to length and heat bent somehow...

Hi, After finishing my last maintenance spree (which took about 1-1/2 years...) I'm left with this bracket. I had put it in a bag identified as "accelerator link" but I can't find anywhere to attach it to and the accelerator link appears to be pretty well supported as is. Any ideas what it...

It was indeed the starter. I took it apart, cleaned everything thoroughly, replaced the brush holder and two of the brushes, added new rubber vents as the old ones were long gone, applied some Sil-glyde where appropriate, greased the front and rear bearings and it fired right up. I have the...

Hi! Any chance you would have the two other brushes which are normally part of the yoke assembly? If not I'll buy this one and scavenge the brushes. I'm located in Eastern Canada but can provide you with a Fedex account number for shipping. Thanks!