What year is your GX? Mine is a 2019. I saw on the website that the front skids fit a GX but the transmission skid is only for a 4runner. I sent an email and the reply was that the crossmember mount is different and it does not fit on a GX. Did you have to modify?
I saw an ARB skid plate install video where the CBI bumper covered the mounting holes and new holes had to be drilled in the skid plates. I was wondering if Budbuilt had the same issue.
Has anyone installed Budbuilt with a CBI covert bumper? Any mounting issues? I was going to go with CBI but after seeing the video where they don't clear the KDSS and had to be trimmed I think Budbuilt may be the way to go. I don't want RCI because the drain panels don't line up.
I have coilovers and set the front at about 2". I used a 1" spacer on the rear. It sits pretty level. I have 265/70-17 tires and had to trim a little so they wouldn't rub. Also needed rear KDSS spacers to clear the spare tire.
I have the 4 mm offset TRD pro with 267/70-17 all terrain tires and a 2" ish lift. I trimmed and they still rub slightly on a hard turn or downhill turn. Also the spare wouldn't fit without KDSS spacers.
I agree. I bought sliders and a bumper and there were zero instructions. Four bags of bolts and I had no idea which went where. I watched their video and it took less than 5 minutes and skipped many steps. There is another video by TX GX? It is much better than the CBI version but it would have...