Recent content by Temecula40

I also noticed the needle housing from two rebuilt kits are different from the original on the right with holes in it. Does one work better then the other? Or just clean up the original?

Thanks guys!!

Sould the carb mount plate have a hole in it for the bolt (hollow bolt) underneath the carb? Is the mount plate restricting anything?

#946 1976 weekend fun

Nice designs! I built mine off the original bumper to make it more functional. Mine is not the best but I like it.

Nice work! What size lift did you go with?

Thank you!

Thanks for the replies. I recently rebuilt the engine and carb. I have the truck running decent(starts and runs good, no loud backfires, chugging). She's runs alittle rich with an occasional pop out the tail pipe and notice the timing bb jumps around at times. I'm sure carb needs better...

Oh I'm sure I'm doing it wrong. 😆 I just rechecked and took some pictures with my settings.

Hi everyone! Here are my ohm readings from the ignition coil. Is it ok or replace? Primary 3.1 Secondary 9.93 Its original...

I see what your saying on the alignment. I'm going to try and shift it to the right a hair! Thx

Why isn't there a mounting ear at the end of the manifold so you can tighten it up on my 76.