Recent content by teleskier

Interesting. Never seen these! But agree, not necessary.

see my previous post on this this thread for a pic of what I am talking about. the stopper is part of the bolt.

Indeed that is what they are for - anti spin. I JUST went through this on my 11/1979 which has the late model body mounts. The stopper is not actually a separate part, but attached to the bolt. It sits in the frame extension that supports the body under the B column. That part of the frame...

Just went thought some troubleshooting on the clear lamp facelift on 07 GX470 and thought I'd post what I found. The facelift involves changing the amber 8155160730 (Pontiac aztec) lamps to clear lamp housings. There are 2 later model year versions - Normal 8155160860 - OR mildly tinted (aka...

I'm going to be in for one in Oak.

Bump. Not yet sold.

Bump. Have one lead on these, but bumping here.

Beautiful truck. Should go fast!

Wonder of this is the wire that would be hot in a Glow ignition switch... so a non-us diesel.

Anyone else have this problem, or more importantly an installation solution? Shop is mocking mine up and reports the cranks might hit bar when everything else looks good.

I am on a few other forums and see the same scam everywhere and they do indeed infiltrate through PMs. BenzWorld makes you have 10+ moderator verified posts before PM is allowed. Painful yes, but if you are committed to contributing to the community, it's only a minor short-term inconvenience...

Was this relay enough to make system work? I bought one of these from OZ for a 1HZ. Still trying to find a wiring diagram with these colors to figure out what goes where as well as where to get the mating terminals. I am wiring this into a BJ40 ignition switch which has the glow feature by...

Thanks for the hard work on these! I'll be ordering a bezel. Going to use the alternator pickup signal on the 1HZ. Considering another bezel on the other side of the column for EGT. Is this harness custom? Looks similar to the JToutfitter harness. What is the black box you're putting the...

If you are referring to the #2 position, these bolts are very very specific to this location. Part number 90109-10039. They have a conical end on them and a welded on flat top. Here is a pic I pulled on google. If you are willing to wait it looks like they exist in Japan/UAE.

Anyone have photos of the front roll bar mount plates in the front floor pan? The plates metaltech provides are absolutely enormous and seem to go half way across the late model floor pan. I plan on using the frame tie in underneath, so it seems a smaller plate would suffice.