Recent content by TEC3

We are selling out 2006 Toyota Land Cruiser recently built for Overland/ Off Road Travel. This vehicle has been built well with only high end parts. You need nothing to hit the trail or travel. Recently just drove to Idaho and back with no issues. Tent and Awning can be negotiated, but are not...

Lol, I know. And yes I would be lifting from frame to allow travel of the suspension I do need to find extended bump stops front and rear to limit up travel if you have suggestions there.

Care to check shipping to 37760?

Just so I make sure sure I’m measuring correctly. On ground I’m center hub to fender well, then put on a jack, lift until tire leaves ground and measure the same measurement?

Looking as we type for a sway bar, not sure why they didn’t correct the issue instead of cutting it to clear the drive shaft. They pulled mounts, end links, everything. 2. I need to see if I have a fire stone locally. Small town. 3. I cut and hammered the pinch weld flat, but may do more. I...

And you mean 60-70mm right? So roughly 2-2.5” of Down travel?

Right, I’m sitting at 22.5 and do not have rubbing with 315’s. Need to measure my down travel. Wanting to drop a little more to eliminate the last bits of some Torque steer. Long story short had a shop do my lift, they cranked it to 24.5, ate CV’s while driving cross country, had horrible...

Could someone with 315’s(35’s) measure from center hub to fender well on both front fenders? We are back from a trip and I think my Torsion bars still need to be adjusted down. Thanks, Tommy

Was looking at scan gauges today. This is slick. How can we order the Mount? @Ayune ?

W Will do. I am doing some research on the best one. Was considering a scan gauge so I could watch trans temps but can’t get a clear answer on if it can read those codes. Also I see on here that some people have had issues with 100’s and scan gauge.

Don’t mind to do that. My scanner doesn’t read the VSC codes, just CEL codes. A suggestion on a quality code reader that will do that would be awesome.

I have a Bluetooth code reader, but for some reason it isn’t reading anything except CEL codes. Would you care to share the one you have that will read ABS/ sensor codes?

VSC/ TRAC light and VSC off light. It’s intermittent, but most common on longer drives. I understand the lights can mean a few things. But my question is the same, is there a good way to read the codes being thrown without going to a dealership?

Recently I am getting VSC and TRAC lights randomly. Mainly during highway driving. I assume I have a wheel speed sensor going out. Next time it happens I’d like to try and diagnose which sensor is failing. Any way to do that without going to the dealer? Since it’s intermittently failing it...

Thanks guys, Spent this morning working on it. I’m currently across country in idaho (from TN) and think I found some of the issue. A hub measurement from center to fender on pass side turned out to be 24.25 while the driver side(toyota lean) was 22.5 I leveled the truck side to side in the...