Recent content by tcorley37

  1. tcorley37

    94’ intermittent loss of power/ cut out.

    I replaced my fuel filter and fuel pump sock. My fuel pressure sits around 40-45psi. I believe I may have a clogged or faulty fuel injectors. I will be testing a spare FPR soon and if that doesn’t fix my rough idle/misfire then I will pull my fuel injectors and have them tested.
  2. tcorley37

    1FZ Fuel Pressure Testing

    I have not experienced power loss recently. I truly don’t know what fixed my intermittent power loss. I’m now dealing with a rough idle, especially when under load. I am thinking maybe a clogged fuel injector because everything on the ignition side seems to be working properly. A buddy of mine...
  3. tcorley37

    CEL Code 25/26, doesn’t seem to be O2 sensor related.

    Do you suspect this is an O2 sensor issue? Even after unplugging the sensors and clearing the code it still idles rough, the same as when they are plugged in. I have read some forums that say you can test the sensors by unplugging them, clearing the code, and the truck should run smooth again...
  4. tcorley37

    CEL Code 25/26, doesn’t seem to be O2 sensor related.

    Hello all, I am stuck. I have a 1994 1FZ-FE OBD1 cruiser with 314k miles. I recently purchased in June 2026 and have been trying to get it to run smoothly. I have an ongoing CEL code 25/26. Instinctively I thought this was most likely bad O2 sensors. I replaced them with Walker O2 sensors and...
  5. tcorley37

    New Product, 1FZFE fuel pressure test adapters

    Mine sits at around 37psi at idle, it will jump up to 45/50psi when I tug on the accelerator cable.
  6. tcorley37

    New Product, 1FZFE fuel pressure test adapters

    I ordered it over a month ago but it got lost during transit. Matt was kind enough to send another which showed up a few days ago. I’m sure he will have more available soon!
  7. tcorley37

    Adding winch to Non-winch ARB bumper

    Here are some additional photos.
  8. tcorley37

    Adding winch to Non-winch ARB bumper

    Hello all, I have the non-winch ARB bumper and wanted to add a winch to it. I looked at getting and ARB winch ready bumper but didn’t want to spend an additional $2,000+ just for this accessory. I decided to try and fabricate a bracket to hold my winch while also being strong enough to not bend...
  9. tcorley37

    New Product, 1FZFE fuel pressure test adapters

    Just got my pressure adapter from CruiserMatt! This thing is legit, so easy to check fuel pressure now. There was a couple things I needed to do during install, I needed to add an aluminum washer where the regulator meets the adapter so the fuel lines are straight as well as shave the provided...
  10. tcorley37

    1FZ Fuel Pressure Testing

    I will check this tomorrow! When this happened to you, did you lose power intermittently or did it totally crap out on you instantly? I only ask because mine will have no problem revving to 5k rpm when in park and most of the time while driving too. It’s pretty random when it decides to cut out...
  11. tcorley37

    1FZ Fuel Pressure Testing

    I will try that tomorrow and get back to you
  12. tcorley37

    1FZ Fuel Pressure Testing

    Used a voltmeter between FP and E1, during startup the volts measured 12v, then, during idle it sat around 9.2v. Seems to have the correct voltage. I am unable to drive the vehicle and view FP voltage at the same time so I assume that under high load, the voltage should increase to about 12-14v...
  13. tcorley37

    1FZ Fuel Pressure Testing

    I would also like to state that while testing my OBD1, the voltage on my oxygen sensors are great, jumping between 0.1-0.9. While testing my VF1/VF2 to E1, the voltage is 0.08v and 1.12v. Very low, after reading my ECU is adding extra fuel to the fuel/air mix. Could this be in correlation a...
  14. tcorley37

    1FZ Fuel Pressure Testing

    Hello fellow mudders! I am curious if anyone has done fuel pressure testing on their 1FZ. I believe I may have a leaky injector, bad fuel regulator, weak fuel pump, or clogged filter. My 94’ 1FZ has lost power intermittently over the past month while the truck is under load, all at different...
  15. tcorley37

    94’ intermittent loss of power/ cut out.

    Did it again over the last couple drives, it once struggled to idle while in park with dropping rpm’s. I believe I have this problem down to a fuel issue. The most likely culprit from research is either leaking/ clogged fuel injectors, or a clogged fuel filter. This would make sense as the...
Back
Top Bottom