Recent content by Subic

Please tell me you got the front blower motor, underneath the passenger side dash. Those are discontinued, and once yours starts squeaking, you will wish you had a replacement.

Do you have the rear hatch wire harness? Highlighted in yellow in the enclosed pic.

No, it was at negative caster prior to installing the Delta radius arms.

I really meant to include that! There is a dramatic improvement in steering and tracking. I did also install the Delta panhard lift bracket at the same time. Previously, the 80 liked to use the entirety of the lane at highways speeds with all of it’s wandering. I was constantly counter steering...

Here is my input on these radius arms. Vehicle: 1997 LX450 Suspension: 2.5” OME lift, heavy front, medium rear, with OME caster correction bushings Wheel to fender measurements: 23.5” all wheels. Caster measurements prior to Delta radius arm install: Left: -0.8 Right: -0.7 Caster measurements...

Do you have the part circled in the picture below that is between the fender flare and running board? I am interested in both driver and passenger side, shipped to 98107.

Gentlemen, I found the cause and got it repaired. It was a worn spindle bushing in the front end. Got both swapped out, and it is good to go!

I already did that a few days back! It resulted in zero change to the noise.

Gentlemen, I have a bit of a nasty noise that just popped up. The sound comes from under the front half of the car. It is a short rattly buzz noise, and I can feel vibrations from it through the floorboards. It is very intermittent, happening once every 10 minutes or so during city driving...