Recent content by STFU

I was looking at that one as well, looks like a decent price.

Has anyone run across a decent rear storage box with drawers for the 250 yet? That aren't $4000....

Your friends will love it!

I still need to replace the inner rocker panels. Found some rust holes when I pulled the factory steps off. But will put some miles on it before I decide if it’s worth moving forward with more cutting and welding. I did pick up some white knuckle rock sliders that I plan to install soon. They...

next the front end, ripped out all of the AHC components including wire harnesses, lines, pump/reservoir, accumulators and valves. That was a messy project. Needle scaled the rest of the frame and front end and painted. Replaced the lower control arms and bushings with dooreman parts and Delphi...

The gas tank was replaced with an aftermarket piece for about $350, quality looks decent. Nice coating on it. Had to buy a new filler hose neck to mount in the tank, but the rest of the parts transfered over using the new orings/gaskets that came with the tank. I replaced both straps at this...

Several other sections were cut out and replaced with new steel. Then everything was cleaned again and painted with Eastwood’s rust encapsulator black frame paint. I ended up finding a good deal in the classified section here for a complete Ironman foam cell suspension kit with all new rear...

The pass side was so bad I ended up cutting everything off from the wheel arch in the frame back and replacing it with new 2x4” 1/4” wall box tubing. The drivers side wasn’t as bad and I was able to spice in a section of the same 2x4 box for the last 24” of frame. I also entirely cut off the...

I recently picked up this 2004 LX470 in a trade and thought I’d see if I could bring it back to useable condition. I figured I would share my progress here. It has 319k miles on it, was a 2 owner vehicle before me. Original owner kept it until just last year and had it religiously maintained at...

I just installed a set of these from Nolathane: Amazon.com: Nolathane REV014.0044 Black Sway Bar Link Bushing (Location Front Or Rear) : Automotive -...

I just completed an AHC delete on my 04 LX and it was a bit of a project. Mine was quite rusty, so every line was junk and most of the nuts and bolts holding the components to the frame were rusted beyond easy removal. The biggest fight I had was getting the upper nuts off of the rear shocks. I...

THanks, I do offer that type of service. Fairly booked up right now, but will PM Joe and see if he still needs some help.

I just saw this post today, so a little late to the game. I run a small independent shop in NH seacoast area specializing in Land Cruisers and vintage Toyotas if you or anyone is in need of service work.

PM sent!

Thats what i ended up getting and it worked/fit fine.