Here's the screenshot of the power consumption on Igloo website. It's odd how they listed the unit as Ah/h. I honestly have never seen it like that before. Cancelling out the hour (h). This unit run about 0.93 A on 12 V so thats slightly less than 12W of power. Typical 120V out let in the...
Just started happening in the last couple of days, but whenever I roll up my rear window, it would immediately roll back down. Even if the button remains pushed. It doesn't stay up. It's raining outside and I have no way of rolling it up. Does anyone have this issue before or know what I need...
I replaced the radiator last month and I couldn't figure out how to remove the brackets unless I remove the bumper cover in order to access the bolts (4) from the front. removing the radiator alone and reuse the old bracket has another challenge, and that is removing the 10mm in the passenger...
I made a mistake of ordering the wrong set (of 8) of spark plugs for my 200-series. It turned out that these plugs fit 100-series (and other Toyota models). Willing to let do for partial cost. PM me if interested
I'm surprised that the "Factory Recommended" procedure doesn't involve bleeding out from the bleeder valves. They're there for a purpose. Either that or the dealer is lying.
So i raised this concern to the Lexus service advisor and below is his response.
"Thank you for your follow email with your concerns. The procedure that is done during the Factory recommended service is a fluid replacement. So, it is done through the reservoir. I confirmed the procedure...
If those rubber cover were taken off, the dirt would have came off or sign of it. Same with the 8mm bleeders, they don't show any sign of wrench touchin them. Also I expect fluid residue on it after they have been bled. These looks like they were all untouched.
Update:. So I brought the truck back to the dealer to get the AHC fluid changed ..at no charge....upon closer inspection after I got home and notice that the 4 bleeder valves where untouched. So it's either they didn't do it correctly by just replaced the fluid in the reservoir or possibly...
eBay. tHere's the link
https://www.ebay.com/itm/1-8-125-Aluminum-Sheet-Plate-12-x-48-5052/264487710103?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649
Just made a custom wind faring out of 1/8" aluminum. I decided to go this route to make sure theres no air gap between the roof and the faring to minimize wind noise. Now I'm debating if I should paint or wrap this black to match.