Recent content by SoCal818

  1. SoCal818

    What did you do with your Tundra or Sequoia this weekend?

    SRQ Fabrications | Off-Road Toyota Parts & Accessories - https://www.srqfabrications.com/ When you decide, these guys are having a sale.
  2. SoCal818

    What did you do with your Tundra or Sequoia this weekend?

    That trail to the back of Dunderberg Peak leads to some beautiful views.
  3. SoCal818

    What did you do with your Tundra or Sequoia this weekend?

    Welcomed the rig to the quarter million mile club!
  4. SoCal818

    Trailing arms - replace bushings or get new arms?

    Thanks. My lift is 2-2.5”. I appreciate the insight.
  5. SoCal818

    Trailing arms - replace bushings or get new arms?

    Yes, you can still buy OEM LCA’s. However my question was about the rear trailing arms. They sell OEM trailing arms but not OEM bushings. So it’s either OEM arms, aftermarket bushings, or aftermarket arms. OEM is always a safe bet but if I’d like to help with articulation on the trails while...
  6. SoCal818

    Trailing arms - replace bushings or get new arms?

    Forgive my ignorance on this. My trailing arms bushings are cracked and moving by hand, though only slightly. At 247k miles and 21-years old, I’m confident it’s time to replace the bushings. Here’s the question - is it generally better to swap the bushings or get aftermarket replacements? They...
  7. SoCal818

    Filter brands and housing

    I second the OEM filters. I started running Mobil 1 synthetic a long time ago and have (mostly) stuck with it. Seems to work well but to echo vtl’s comment, any good oil with a Toyota engine will be just fine.
  8. SoCal818

    Tundra air down question

    If you’re not riding on a wide tire with a narrow rim (ie: a higher likelihood of popping a bead), then I suspect you’re good down to 20psi but bring a full size spare to be safe. Heck, you can probably go down lower than that but with a thinner sidewall that potentially creates other issues.
  9. SoCal818

    Thoughts on value

    I’m not sure but I bet if you dig through BringATrailer.com, Autotrader, etc you might be able to find some examples with your situation. I think there were so many replaced frames during the recall the impact on valuation wouldn’t be too dramatic but I don’t know for sure.
  10. SoCal818

    Liquimoly MOS2 - anyone use it?

    Responding to my own post in hopes it helps someone else with this question.
  11. SoCal818

    Liquimoly MOS2 - anyone use it?

    Thanks. My wallet thanks you.
  12. SoCal818

    Liquimoly MOS2 - anyone use it?

    I’m admittedly old school and believe that consistent oil change intervals with good synthetic oil is generally all you need to keep your engine internals operating properly. That being said, I was having a conversation with a buddy who said he swears by LiquiMoly MOS2 in his 5.7 Tundra. He...
  13. SoCal818

    Gen 1 Sequoia suspension setup/build and driveability

    These are good points. I failed to mention I installed JBA upper control arms as well as extended sway bar links.
  14. SoCal818

    Gen 1 Sequoia suspension setup/build and driveability

    If you run 35x10.5r17, you should be fine with a 2.5” lift so long as you cut out (or hammer back) the pinch welds. For comparison, I have a 2”-2.5” lift and after cutting back the pinch welds, my 33s have more than enough clearance for 35s. As for drive-ability, if you stick with Load C tires...
Back
Top Bottom