After 4 years in exile(honda accord), I am finally back in a 200. 2014 Land Cruiser. Garage kept its whole life. The truck is in close to showroom condition. Not going to mod her much, but I will do wheels at some point. It's good to be back!
I lost my LX to an accident over a year ago, and I have been wanting to get another since. I’m almost ready to buy again, but am conflicted. I prefer the Toyota badge greatly over the Lexus badge, but the wife and I both loved the ahc. I vaguely recall reading somewhere that some us spec...
I second this. I followed another posts recommendation and switched to filling through the filter. I used a funnel zip tied to a ladder and a length of 3/8 hose for my subsequent fills. The amount of fluid mix between the old and new is pretty negligible once you do a few bleeds, and there’s...
The cavitation stopped once it had cleared. My pump sounded normal when reversed, and would run normal for a few seconds when I then changed flow direction. I repeated this process until it functioned normally.
A word of caution here. Absolutely do not use tech stream to run the pump for more...
Sorry for the slow response, I’m sure you’ve found it by now but..the power plug for the ahc is on top of the frame rail right next to the spare tire. It’s pretty easy to drop the spare and slide under the rear bumper to get to it. It’s a surprisingly large plug, probably 2-3 long, light gray...
The pump is not self priming per the techs I’ve spoken to. Bench priming it is done by reversing the pump, pulling fluid from downstream into it. In theory, it pushes fluid back into the reservoir. But, if there is air in the pump or line, you may not see much change.
The only reason fluid...