Recent content by Skeenextreme

You only have .2 of a second between alternating the ground contacts. I think usually people are too slow alternative the wires.

Try going faster. I did mine faster and it worked. No pause between taps.

The trick seems to go faster than you think in the sequence.

I'm going again this year in the LX450 along with the whole gang; My brother in a 4Runner, other brother in a Taco and Pops in a 88 truck. Can't wait !!!!

Only pulled rear section off T-case and left cross member attached to case; just lowered case a couple inches with floor Jack.

Yeah, I installed the gears myself. It wasn't to hard, but you must have a press for the bearings. Reinstalling the gears is the hardest part just because they are a little heavy. 3:11 were great on Runithon. I ran Little Sluice with no problems.

Rubithon was a blast. Glad I installed the 3:11 T-case gears a few days before Rubithon. Already planning mods for next year.

What's the current Rubithon rig count?

Has anyone found Toyota replacement flange studs for the front flange on the rear driveshaft of the 80? I have searched around and haven't found them. The only part numbers I can find are for the bolts and nuts on the axle side flange and a part number 36209a for the front flange assembly but...

Anyone have the count for Wagon Run or total Rubithon tickets sold to date? There are two in my group joining the Wagon Run.

Just purchased my Rubithon entry. I'll be joining the Wednesday Wagon run in my 97LX450!!!

I think I'll go that route. I just picked up the Trail Gear transfer case reduction gears for $274 at my local 4wheel parts store. Getting her ready for Rubithon 2016!!!

Looking for a machine shop near San Diego that has experience machining the double snap ring groove for hub part time kit install. Has anyone used a local shop?