Recent content by Since 1995

Yep, a clearance or marker bulb, front, not side that comes on with the lights replace bulb with 194 (NAPA BP194) 14v 3.8W 0.27A,

All the 10mm is not correct, way too short. The threaded part stock screw before the shoulder is 3/4" or about 19mm. I will try again!

I started narrowing it down, thank you

I have a 2000 LC and am going through trying to clean it up. In the process I am removing what Toyota calls garnish, I call interior trim. I am trying to locate the trim clips proper for the various trim/garnish pieces. To begin with I just want to grab the most common, so far what is see is...

Thank you

Thanks all, I will stick with "B". that is, remove the carrier. install the hardware (I ordered it from McMaster Carr 97654A683: M8 x 1.25 10mm 18-8 Stainless Steel Flanged Button Head Screw 90133A615, M8 Screw Size, 8.4 mm ID, 16 mm OD Oil-Resistant Neoprene Rubber Sealing Washer I have the...

I want to delete the factory roof rack on my 100-series 2000. Removing it seems easy enough. Once the rack is removed I assume I need to weather proof/seal all 12, M8-1.25 inserts using a flange head bolt with neoprene washer. I would also like to remove the entire roof drip molding, as it it...

Greenbean. I have a 2000 LC and want to complete remove the roof rack, and seal any possible "leaking" areas on the roof. It looks like there are PEM type nuts that the rack fixes to which may be a source of leaking. Then I want to replace the roof drip moulding with a single strip with RH...

Bisho, can you take a pic of where the measure on should measure the front of the glass weatherstrip and the back of the opening. My sliding roof only tilts up and down and does so with a struggling sound. If you can that would be great