Recent content by shansen

Not bad from what I recall.

My 1990 BJ75. LHD, 3Bii, H55, Cable lockers, duel fuel tanks (LRA in tank added), AC, bed is from a later model 79 series

Trying figure out what the function on this part is, Planning on adding a turbo in the next few months to my 1990 BJ75, 3bii engine. Recently when installing rebuilt injectors, I had the air intake elbow off and now I'm curious what function this flap serves. From what I can see when...

Last steps were to insert the long bolt through the recovery point and bumper, and insert the bolt into the nut that has the connected rod. Tighten everything up and its done! Very nice design, workmanship and functionality of this piece. The price was also great. Thanks Charles and Rob!

As you can see, the bumper does not need to be removed for this install; this was very well thought out and extremely easy to install. View from above, you can hold the lower nut in place with the connected rod, or adjust as needed if you bump it a little

First step was removing the existing long bolt that goes through the ARB bumper and frame Next step was to place this nut above the unused hole in the ARB bumper. Cool design, makes it easy to hold this in place while you do the next step, which was to insert the recovery point through the...

A heavy little Christmas gift in the form of an Odd Iron Off Road 70 series recovery point showed up today. I pulled the Cruiser in from the rain and started the install. About 15 minutes total with a 19mm wrench and socket. Good instructions were provided, though I took some photo's as well...

If anyone needs a locking gas cap that fits the Toyota spout (not threaded), this cap from Napa does the job. Part number 703-1842, about $12. I have front and rear fuel tanks and while Napa does not sell a key-matched set, a little calling around helped me find two of them with the same key...

And last, the finished bed cover on the flat bows. Uses the factory hooks on the side of the bed with a UV resistant bungee that wraps all the way around. Up front it was trimmed to work around the tire and hi-lift jack, using straps and uv resistant buckles to grab on to the factory spots on...

Another project in recent weeks was to get a cover for the bed. When driving off road for camping, etc., I'm hoping this keeps the dust down a little. I put the cover on a couple months ago but it was sagging in the middle. Found some aluminum at my dads house and we built this. Fits well...

Uploading some pictures of the injector installation. Ordered new injector "seats", the first one you can see has been placed in the bottom of the injector hole, it's kind of like a crush washer. The larger ones in the next picture go around the injector port, I dropped those in next as you...

Injectors arrived back from Diesel Fuel Injection Service today; they look amazing. They replaced the worn out parts with new Denso parts, tested and sent priority mail back to me. They also included a bunch of bonus stuff in the package, notebooks, keychains, calendar and a couple pens that...

I don't believe he is active on this forum.

Next items was pulling the injectors. Pretty easy following the 3B FSM I have. Removed fuel lines (17MM wrench), removed air intake and disconnected throttle cable to give a little more room. Next I removed the nozzle leakage pipe (19MM), and finally removed the injectors (27mm deep well)...

Two items this weekend, finishing up the electrical on the LRA tank and pulled the injectors to have them cleaned/rebuilt if necessary. Needed to find a spot fo the LRA fuel pump transfer switch/fuel gauge. It's the size of a cigarette lighter and could go into that spot, but I have the OEM...