Recent content by Sashfj

I’d bet money on it that the resistor was the problem all along - in my case cleaning of all of the contacts and replacing the resistor sorted the problem after much time and effort in throwing parts at it :)

Bula ! 2001 ? that’s ages ago mate you’re due for another trip I reckon yeah based in suva have a great weekend :) and thanks again for your help

Mate I need to buy you a beer ! all sorted now - happened to be a dodgy contact and everything did with a good clean also:) if you’re even in Fiji please let me know :) thank you so very much

HI again Ross, I think I have a slightly different setup but im assuming that the trouble normally is with the plug in the foreground (bluish colour in my picture ) thanks in advance :) kind regards sashi

Thanks Ross, will get my auto sparky on to it tomorrow and let you know how I get on - fingers crossed kind regards Sashi

Guys ? Anybody ? :)

Hi Hobie, what did you end up doing for your 2002 model ?

Also - can't find a pic of the famous wire or plug so if anyone has it would be very grateful to have a look at it too !

hi sorry to resurrect this thread - but having the same issue in a 2002 LC 100... the last post says that it may not be the wire .. but I get a p1123 and intermittent limp mode... fixes itself by turning off and on ... sometimes have to do it more than once any help would be much appreciated...

HI Everyone again ! THE AHC is finally fixed !! it turned out to be a pump (had to replace the whole thing) apparently the old pump was just not strong enough which makes me think the although we refurbished it by changing the subassembly the mechanics may have done an ineffective job :( island...

hi everyone - still struggling with our old girl.... just scanned and got the following codes and live data - any help would be greatly appreciated ... a local auto sparky told us to change the pump motor (a very expensive part :( ) not sure if this is the solution but getting to my wits end now...

Hi again team , So what has happened since the last post is that the c1762 is still there .... we have tested the motor (works when direct power applied) tried the shorting if the dlc to bleed the system (apparently hit an miss according to the forums) , tried to bleed the system manually (no...

i have cleared the fault codes and the c1762 is the only one that came back :)

HI again everyone ! back in fiji and having a look at that LC of ours by myself now :) so just scanned the vehicle and came up with c1762 error - i have been through the trouble shooting and found that relay was bad - have installed a new relay in the Engine JB and the back of the vehicle has...

Thanks for the very efficient reply PADDO - will make some time to get through this and and let you know how it goes :) I might owe you a Fiji bitter (or dozen) next time youre in my neck of the woods ! .. fingers crossed