Recent content by Sarrus25

Was it obvious that the belt jumped a tooth? O was it more like a "half" tooth jump? (photo attached is from my engine with the same issues)

What gaskets did you install?

jgray, did you end up figuring this out?

Looks good! Which pitman arm / links / steering arms did you go with?

Correct, I changed the drag link as the truck had a worn aftermarket link installed. I was actually wondering if my steering arm was stock or not.

Attaching photos. Does this look stock or modded? I don't have a baseline, this is the only factory solid front axle Toyota I've owned. A lot has been touched on this truck before I bought it.

This looks great, man! Do you have the HD front OME springs? I went with standard and they seem to have much less arch than yours (attaching a photo).

Nice! Are those the steering arms you're running? Did you modify your knuckles yourself? I have a Bluetooth OBD2 scanner hooked up ('96 2RZ in my truck) already that I can access via my Android device. Do you know what type of sensor data I'd be looking for in order to see TPS readings?

I have a new drag link and ensured all moving joints are tight. My slop comes from a worn out steering box unfortunately.

How can I validate TPS function? I know it's doing something because the truck doesn't run properly with it unplugged / throws a CEL. Any tips for high steer on a stock ish build?

Fuel pump, tank, and feed line are brand new as of December

Been awhile since I've posted! I've been driving my build a lot since plating it. A few notes: Engine Hesitation / Cutting Out I have some inconsistent engine hesitation between 2000 - 3000 RPM under load that I haven't figured out yet. I've done some work to eliminate possible causes: New MAF...

Any way to tell? Here is the link where I bought mine 👀 https://www.ebay.com/itm/323903509443 I'm sure the part could be used with some milling and maybe a bit of cutting / welding, I'm not equipped for that at the moment. Happy to offload it to someone else if they can use it.

Wow, such a clean build! My block looks like it was pulled from a swamp 😂

Here is a video we captured of the first drive around the block on the new OME suspension. Woot!