Recent content by Sandman614

  1. S

    BP 51 Suspension Rebuild Process

    Hopefully this is the last from me on this. I bought a no loss gauge capable of 700psi($70), the wrong size 1/8npt to 1/4 flare adapter($5), and grabbed 1/4npt to 1/8npt reducer from my stash. Talked my HVAC Tech neighbor into letting me use his nitrogen. Unfortunately he doesn't have an...
  2. S

    BP 51 Suspension Rebuild Process

    Still waiting for my buddy to get his nitrogen setup. I decided to swap the hose and oil on the 2nd shock that the shop was supposed to get into the same as the first. I sure was charged for oil and seals for 2 shocks.. Now you tell me this oil is new with less than 1000 miles.
  3. S

    BP 51 Suspension Rebuild Process

    Since my rings weren't leaking I didn't take them apart. I've already got the shock back together, refilled, and waiting for nitrogen.
  4. S

    BP 51 Suspension Rebuild Process

    I just ordered new orings for my schrader valves and saw theoringstore had this oring inspection/measuring sorcery. My oring measurements were based on the diameter of the piece they were on. This tool showed the schrader valves smaller than what I measured for a tighter fit. Olypsys | Advanced...
  5. S

    BP 51 Suspension Rebuild Process

    I ended up making my own pin spanner because the one I bought from ebay, we'll you judge.. Also you'll need a 38 or 39mm 'blind inner bearing puller' to grip the inside lip of the IFP, since there is no threaded hole like other brands.
  6. S

    BP 51 Suspension Rebuild Process

    I finally manage to get the caps off.. now here are my measurements on all the seals and wipers in the rear shocks and the closest Viton match from theoringstore
  7. S

    BP 51 Suspension Rebuild Process

    While I wait on the hydraulic shop for my hoses, they said they'd have to special order the fittings.. The previous shop had a hell of a time getting these caps off and mangled the pin holes. Since they had them off, I figured this would be much less hard for me.. Or maybe they didn't actually...
  8. S

    BP 51 Suspension Rebuild Process

    I didn't see oil capacity measured, so here's what I could get out of my one that leaked(just over 12oz after getting the hose all the way off and cycling the shock more). These were "rebuilt" by a shop already so this isn't factory capacity. And the fittings measure to be oring m10x1.0
  9. S

    BP 51 Suspension Rebuild Process

    Do you by chance know the thread and banjo size on the hose? I'll be taking mine off to measure but figure you might have beat me to it.
  10. S

    BP 51 Suspension Rebuild Process

    @Aslantarek thank you for your work! ARB told me My hose I suspect is leaking. I had taken them to a shop and they said no they'd give it a shot but no warranty because no OE parts were available. Well I get them back and the hose is still leaking after driving on the street, no offroad...
  11. S

    BP-51 Rebuild Mileage Poll

    Yes, both rears were warranty replaced because they leaked within 6months/15,000mi. The fronts have not been replaced but the bushings have worn out several times and I finally made correctly sized spacers in the same material all other shock makers use. I had thought about sending in my shocks...
  12. S

    BP-51 Rebuild Mileage Poll

    Well I guess this is the end of ARB/OME for me. According to arb tech support since my shocks are an early serial number and they have changed design they no longer carry parts for them and have determined them to be "end of servicable lifespan". Solution buy new BP-51, That will not be...
Back
Top Bottom