Recent content by Samuel642000

I saw it as buy once cry once, and the OP did ask for something above an OME ... just tossing my opinion/experience in (def not saying I disagree)

I put a King damper on mine, no complaints

Mine were awful, leather was cracked and torn (like they all are) but also had foam missing and no arm rest. I think this ended up being a little more than recovering the stock seats, but a mich better result.

Used Father's day and knocked out the rest of the Range Rover seat install. Everything works minus the heated portion. Haven't got that far yet. Editing to show how much these move back, and head room. I'm 6'2" and have about 3-4 inches with the chair all the way down. And it will almost...

Got to check something off my bucket list today

Aware, yes. I was just (wrongly) confident I could get them to work. However they are working now just needed some Toyota influence

Grabbed some Range Rover seats, found out there's really no way to make the driver seat work with the factory RR wiring/switches. With the factory cruiser seats having switches that control the motors I stole the wiring and switches out of the factory cruiser seat and blended them into the RR...

Sounds great, I'll be following along.

I'm worried for my wallet when I ask how much?

Awesome! Do you have any notes on the wiring mods you did to the painless harness? And I am excited to hear there might be swap parts available soon. What you're doing to the engine sounds very similar to what mods are on my truck currently (dual disk clutch, 90 horse injectors, mod'd cp3, head...

I'm about to pick up the exact set, if you have this available I'll take a write up!

This is exactly what I want to do. My daily is an '06 cummins and I've been looking for the same engine to stab in my 80. I might have missed it but what transmission are you going with?

I've done the entire thing using those files.

Bro, my post above yours literally gives you a site for directions... but I would hate to point out the obvious.

Bump