Recent content by ruggedrudgate

I think we have the same problem. Happens once, at the same exact stop light after leaving my house and is getting slightly worse but not terrible. Then doesn’t happen again till the car sits for at least 8 hours. How quickly did yours get worse?

Are you still parting out? I desperately need those 2nd row seats.

Looks great. I should buy a press. Thanks again for the info!

My man. Thank you. How much time did the seals/bearings take? Looks like I’ve got a sloooooowww leak front and back. Not enough to affect levels but leaking nonetheless. Was considering putting it on my procrastination list.

Anyone with a 100 (2006) have cracks like these on your transfer case? I saw a couple posts for non-100 series but couldn’t find one specific to the 100. They seem to be surface level after scratching at them but boy are there a bunch of them. Pretty sure they aren’t casting marks. That would be...

Appreciate that. Did you pull the shaft off and take it apart to clean it, or did you just force it though the zerks? It takes quite a bit of force to get it all the way through. So much so that I was concerned about the pressure so I unscrewed the zerk and it popped out with a pop noise when it...

The issue is making its way around the rear end. It’s now officially and consistently on the rear passenger side. A slight knock when accelerating from a standstill. I put it in 2nd start and it didn’t knock/clunk. Doesn’t happen when releasing gas pedal or while accelerating when rolling. The...

If it's got a shaft, I'm replacing it.

Done and just replaced. Holy smokes they were bad. They were being replaced anyway I didn’t realize how much my back end was sliding and damn is the ride better. Tightened it up real nice. I have every bushing for the 100 in a bag and this is kind of forcing me to put them all in. BUT the change...

See this is interesting. Something I’ve noticed as well that I forgot to mention was the feeling on the axle sliding backwards when accelerating. On to check the bushings!

Jacked it up and moved the wheels. I’ll get a helper to try it out again. Pinion bearing is interesting. I’ll put that on my list. Thanks!

Hard to tell since the tires are only 6 months old so very little wear. New pads as well. It feels rotational if that makes sense. I’m thinking drive shaft or rear diff but I don’t know if there is an order of operations to track it down like pull drive shaft or open up rear diff or if I should...

Hello all. So I’ve read every thump and bump thread on the 100 series forum and have yet to come across a similar issue. Maybe I’m not inputting proper terms during my search but I think I’ve tried every description I could. 06 LC 230k Issue: At mile 1.5 from home, and mile 0.3 from work I...

Update to my wiper issues. It was a “broken” wire about 10 inches into the harness. Looks like the wire cracked, and water/mag chloride got in and corroded it to the point of it turning into a green powder. All had been returned to normal.

Set of 4. Will not sell separately. Prefer Denver area. Taken off a vehicle I purchased. 5x150 bolt pattern. Tires are from a sequoia/tundra. Bit of curb rash from previous owner. 275/65r20 KO2s on them. I’d go and replace the tires but you can probably get another 5k miles out of them. I’m...