Early one is 1 3/4" center to center.Later is 7/8" center to center.Maybe different thread size also Plate as charliemeyer007 suggest would
let you use older one as one on right above.Tit on back of arm on newer one on left is for rubber support to windshield to keep from vibrating I think...
Will be doing the same.Like advice on using steel screws,Button head allen look very close to reveits on OEM .button head allen.Planning just past flush on back side and staking them with a punch.If need more and not trying to preserve paint weld.I have harvested some to replace broken, what I...
Look into Redlinecruisers.com switch plate that replaces Ash tray.If you like the look of it that might do custom holes for your switched or could get the round switch that fit in drilled hole.
Did similar on my front springs.To check before welding all in mounted top spring only and drew down to flat and inverted to check travel of shackle.(flat clearance then as inverts starts back). Yours is looking good your doing good job posting picture's,I'm to tech challenged too.lol
Don't know if this would matter but running Hydroboost brakes so no vacuum off Sniper and new vacuum advance distributor W/ Petronix and there Flame thrower coil from Redline.
Set at 700 rpm for start up on fresh rebuilt and break in cam on 2F engine.Everything went well on that just think I need to set lower now, Whats everyone think I should lower target RPM's too now?
Everything pb4ugo said here is exactly right (expecially reusing line nuts new ones don't fit as good as taller). This is how I did mine also. Nicop also easy to form around a pipe to make your lines( Loops like factory ) from body to frame for movement.