The interior is mounted to the tie down rings bolts and i built the rear bumper by flipping the rear hitch and plated around it using the factory bumper molding.
There are a lot of parts on the Opt Off-road site for 3rd Gen 4Runners but it all depends on your budget and what you plan on doing with your 3rd Gen.
https://optoffroad.com/collections/4runner-3rd-gen-1996-2002
Duro Bumps (Extended Dump Stops)
Overland Customs Extended endlinks
OEM Rack and...
I finally located the leak on the 80 and it was coming from the steering pump. I looking for a used 80 steering pump for me to rebuild and if anyone has one email at rics974runner@yahoo.com or text me at 856–264-3966.
Thanks Ric
If you have a good alignment, then you should be good on the camber adjustments. Make sure you take alot of pictures of the position of the camber bolts. When I did my camber gussets and camber detete plates my 3rd gen dove straight and i have not had a alignment since then. Going on 3 years now.
Here’s my installation of the slow close kit and I swapped the washer and drill template so the template is on the outside instead of the inside. Hopefully I installed the kit correctly and wanted to post pictures from my installation to help your next customer on the installation of the updated...