Recent content by Prvbs 2717

Price adjusted

What’s your phone number and I’ll text you photos. It’s easier to do that than to try to attach them on here

Yes, that’s what this one has…original leather

1997 40th Anniversary Land Cruiser -1FZFE in-line 6 -256,225 miles -clean title in hand - no rust but color and clear coat are fading in areas -all doors, hood, etc have original factory stickers (nothing has been replaced) - frame is in excellent shape. I treated it with wool wax while I drive...

Price. Unless there are major red flags to using JDM motors. Landcruiser heaven has JDM’s for $3,600 and under 275k. My 1FZFE started knocking real bad back in spring. I parked it and haven’t started trouble shooting or taking it apart yet due to job situation. Now that my job is lined out...

1FZFE

I have a 97 LC with an engine that may need swapped out. If I were to source a JDM spec motor from landcruiser heaven would it be a simple “one for one” swap or would I run into wiring harness and electrical readout issues since the JDM spec motor does not have an ERG ?

The down side is that the LC is my daily driver so I’m currently borrowing a vehicle until I can find a “new” daily driver…more $$

It hasn’t moved since the day the knock started.

I am leaning much harder towards a swap out of a lower mileage 1FZFE, finding a rebuilt 1FZFE to swap it out with (believe I saw someone selling rebuilt long blocks on here), or attempting to rebuild it myself. If I can find an el cheapo daily driver in the interim then that will make the...

Received the oil analysis results (shown below). I have no knowledge or experience with oil analyses but the comments sections describes elevated levels of aluminum, steal, and tin.

I may be replacing the 1FZFE on my 97 in the near future. Either a “new” 1FZFE with current tranny or swapping out to “new” manual tranny at the same time. My current exhaust has a small leak under the passenger side (between 02 sensor and headers). Figured I’d be ahead to just replace the...

anyone have suggestions on best place to source a short block or long block?

My 1997 FZFE developed a knock last Friday on my way home from work. The odd thing to me is that it did not have any audible precursors (at least none that I picked up on). The truck lost power three times within a mile of the house. The knock now starts at initial start up and is very obvious...