Recent content by PNW80Series

  1. P

    AC/Heater Duct/Tube

    Definitely will do, Nick. Same if you get in the PDX area. Peter
  2. P

    AC/Heater Duct/Tube

    I'm in Camas - 15/20 min from PDX, but on the WA side.
  3. P

    AC/Heater Duct/Tube

    Try this link out ... Air Vent - Toyota (55680-17050-22) | Olathe Toyota It may not be #1 in this pic, but you should be able to ID the part and start finding.
  4. P

    I want an 80 now

    Good thing you didn't go with the red. @Will Van was just asking about it, and upon inspection, deemed rust prone and not worthy of price ;)
  5. P

    What to tackle first - Newbie

    Oddly enough, most came up with minimal issue - not sure if it's because it was a Cali car and the heat eventually took away adhesion from the padding. There were a few spots where the padding retained adhesion and that nasty fuzzy stuff remained. In those spots, oddly enough, spraying WD40 and...
  6. P

    What to tackle first - Newbie

    Went with medium - I don't have plans to put on the weight (ARB bumpers, winches, etc.) to justify the heavy and was told swapping coils down the road is relatively easy (if I change my mind). I like height and cornering, but now have to get some slee sliders/steps to help get family in/out, and...
  7. P

    What to tackle first - Newbie

    Am SO glad I read this. I paid $15k for mine, and was thinking I was nuts. Mine is also unlocked, '97, and 138k miles. Interior is amazing. Like everyone else, started with front end rebuild, O-Ring, and then treated myself to a 2" OME lift to accommodate the 285s the last owner swapped. So not...
  8. P

    Noob question re: antenna

    OK, new mast is here. I followed this video - - but am running into a snag. In the video, it shows the cord coming out with zero resistance. However, on mine, my cord isn't coming out. I tried a decent yank, but still no luck. Any tricks on how to get the old mast cord out?
  9. P

    Noob question re: antenna

    Yes, stock radio - with a few missing buttons to make it "vintage." RE: antenna up/down - seems to function just fine; rises when I hit AM/FM, lowers (into that cave) when I turn radio off, or move to CD/tape; the antenna up/down button works too. RE: Ball - yes, there's a ball at end of it...
  10. P

    Noob question re: antenna

    OK, all sorts of threads on how to repair an antenna, however, I'm wondering if it's normal for them to receed completely. Here's a pic of mine, and you can see it goes all the way into the hole (gentlemen, hold the jokes please). I thought the top/ball would be aligned with opening to keep...
  11. P

    Re-installing 2nd row seats

    This. Exactly this. In like a charm. Thanks guys!
  12. P

    Re-installing 2nd row seats

    Thanks guys, off to try again... let you know results.
  13. P

    Re-installing 2nd row seats

    Hey guys, Second post (first was in registry) and am a bit embarrassed, but figure if anyone can help, it's the community here. I pulled my 2nd row seats to recondition leather, which was easy enough. However, having a heck of a time re-installing. My approach has been to install the back most...
  14. P

    Registry 80 Series Registry

    1. '97 Cruiser 2. Peter and Nate 3. Frank The Tank (with custom Da Tank plates, of course) 4. 138K 5. Basic maintenance - rebuilt knuckles, replaced oil pump O ring, Distributor O ring and front main seal ... plus OME 2" lift, and CDL switch (which was a no brainer). Also replaced carpet...
Back
Top Bottom