Recent content by pdot

Very interested! PM sent

Heads up, I made it to Ouray yesterday (Thurs) just in time to see the smoke roll in from several nearby fires. Edit: sky is clear since then

Looks like Black Bear was opened today: San Miguel County Colorado Road and Bridge - https://www.facebook.com/smccoroads/ But Imogene is still closed. Road Conditions | San Miguel County, CO - Official Website - https://www.sanmiguelcountyco.gov/406/Road-Conditions Edit: doh, the Imogene...

Here's my setup with the cheap Amazon terminals mentioned way back by the original poster. Still seems a bit messy, but better than before. I've had these for over a year and have held up well, but the fit to the battery terminals is not great. Anyone know of a good cover/flap that can be...

@ga12r1, when is trail selection happening? Same trails as last year?

Hope I'm not talking out of school but... I went to Dissent this morning to pick up some bolts, and I talked to Ben about this bumper. He said they would likely do another run once they get through a backlog of current work. Best thing is to sign up for emails on the product page.

Fwiw: there is ethanol free 91 octane in Silverton according to pure-gas.org. Could be a good experiment to run at the event.

Reviving this old thread to share my highly sophisticated solution, consisting of an M8x1.25 eye bolt and a zip tie. Disconnecting the bar seems to add an inch or two of uptravel on my truck. With the sway bar connected, the wheel was well below the fender, but just barely tucks in when...

Glass seems quite pricey. Is it OEM? If insurance is covering it, might as well. Make sure they use the plastic rivets in the side moulding and definitely not screws.

@TRAIL TAILOR any more details on the UCA? I don't see them on the site

that's a really cool bumper design

The Nguyen bumper has been in the works for a while. Looks like it could be a good alternative.

Reliable Auto Glass in Auburn CA has done mine twice. I talked with their install guy who was familiar with the rivets and moulding on the 100 before I brought it to them. Did a great job afaict.

Hell yes! Thank you for starting this thread! I have the normal Dissent rear with swingouts and it's good, but I would be stoked to switch to the extreme one for simplicity and extra clearance. I've been emailing them every few months to see if the extreme rear is coming back. And every time...

Not meaning to threadjack, but what trail is this?