Recent content by OkiGoose

I wasnt able to find one without the switch shown, but I believe you. I'd be willing to say its locked.

I'd be lying if I said I didnt just look at plane tickets. I've been itching for another RHD 80.

No? IH8Mud discount to $20k if sold soon.

EDITED: Wow, I was crazy on price. So, new, lower price. How’s $17,500 sound? Basic run down: 205k km Triple locked Factory winch Ice box center console 4" suspension 35x12.50R15 (need replaced) 15x10 Mickey Thompson wheels Factory everything else. Legally imported and registered in Nevada...

Nooooooooo. Fair enough. I realized I'm missing mine. Upsetting.

From my understanding in the diesel side Of things, yes you have to. I'm also going to replace mine. Aka I don't have one at all I've discovered.

Boost, EGT, water temp, and oil pressure are all sitting in the box waiting to go for when I can throw them in. Unfortunately I have to pack the LC up this week and ship it to the states. I'll have to put all this on hold. Last minute orders tend to take priority. Thanks to everyone for all...

It's changing flat foot at 2k. Changing cable, adjusting shift linkages, new filters. See where I'm at from there.

The left rear simply doesn't work. The right rear did work, as of today, it stopped. I'm just gonna suspect the motors are out. It was really slow before it died.

If you put the trans in 1, it holds the gear. However, I'm not getting much turbo response on the top end. I may just be expecting a lot more than it has though. When you manually upshift, it shifts as you'd expect, drops revs etc, still doesn't like making a lot of power. I'm starting to...

Just about 18L/100km, depending on driving conditions. It's a little inaccurate since my speedometer isn't calibrated, but that figure is with the difference calculated.

I'm ordering the cable tomorrow. Hopefully I can get get it done before I leave island and ship the HDJ stateside. I think it's a good idea to start with see where I'm at. It's the hydraulic. And i downloaded the FSM. Thanks.

The only time I'm getting white smoke is a little on startup and then it goes away. Never any black smoke. When I disconnect the boost comp, is the point to crest a vacuum leak or should I plug the line to isolate the boost comp? I.e. Unattaching the line will create a vacuum leak, is that...

I just got it last week, it's been like this since I got it. I'll unplug that line. See how it goes.

Funny story, kick down cable needs adjusting so much, it doesn't even exist...