Recent content by OhioFJ

bump

There should be gaskets on either side of the block off plate or insulator plate. I believe I have the 12A piece if you are looking. I also have a 10/'79 truck

I put a bolt in mine and welded it shut

I *think* these are correct. It’s been a while These guys seem to have them if you can't get them at your dealer. Maybe determine the diameter before buying...

I might have the parts bag from my order. I’ll check

https://vintageteqparts.com/products/oem-toyota-genuine-parts-fj60-2f-engine-updated-upgraded-exhaust-manifold-to-front-down-pipe-gasket-and-special-unique-hardware-torx-studs-and-locking-flange-nuts?_pos=6&_sid=a9df8285b&_ss=r

Shameless plug https://forum.ih8mud.com/threads/toyota-am-fm-radio-12v.1262114/#post-15877811

$200

Sold

Sale pending, but these are the sliders that came with the pro-90 seats. They aren’t year specific.

$50 for everything you see. Shipping included in the continental US. These are from a set of procar pro-90 seats. I ended up using my oem seat slides so these are new and unused. PayPal or Venmo

At least I know that I'm not insane.

Whelp that was indeed annoying.. All I had to do was: -Have the refrigerant evacuated -Unmount the whole condenser -Realize that the refrigerant line and heater lines were too short, hence the incorrect mounting by the PO -Get a bunch of fittings and new lines -Buy a $100 dollar special...

Started an annoying project. Have to move the vintage air unit over about 3”. PO installed it too close and the spring will not it fit.