Recent content by Northwestern

Thanks for recommendations and photos! I’ll post some pictures and let you know what happens.

The Wet Okole - do they fit the bucket seats pretty well? Looking for something that fit well unlike those cheapo ‘walk-mart’ ones.

If your looking to just lift the rear an inch or 2. What about doing something simple with a toytech lift https://www.toyteclifts.com/b-15-p-toytec-1-5-rear-blocks-without-u-bolts.html

Isolatr, Any chance you have a picture of them in your rig? Look pretty solid. Be interested in that TDR pro black with gray trim.

87 4Runner with nearly mint SR5 seats. Little no stains expect a bit of coffee from a rough morning. Am a pretty dirty guy 24/7 plus two dogs that LOVE mud! Am in the market for some quality seat covers that will save my seats. Something durable yet comfortable. Does anyone have experience or...

Would a worn steering (gear box) have similar issue? Floating steering - and a bit sloppy?

Gnob - Jefferson State local as well. Thank you for the advice - Adjusting the caster will effect the feel of turning the steering wheel at all speeds? Currently it feels like a big old boat. I did adjust my adjust nut on my steering box but was worried about binding issues. Though it does...

Hey y'all I have a fairly well built 87 4runner/ Manual 197,xxx mile. Rebuilt front, Tie rod to pitman, Upper,lower ball joints & new shocks. Alignmented recently but seems like it might be one tooth off on the pitman arm? It goes straight but the steering wheel is a bit off. Personal...

Check you Idle control the screw on the throttle body. It's a 2 cent o-ring that can give you lots of issues. Second is to check all the connections and make sure they are tight. Good Luck.

Pacer - Does your Land Cruiser have about the same spacing as a first gen 4runner?

Question regarding factory build & specs - I recently picked up a set of Toyota Original wheels - see picture below. Has anyone run KO2 LT 215/75? Will they fit? The wheels themselves need to be cleared - Going to bring them and see if they spin correctly with dents

Looking to source some vacuum lines and change everything over to silicon. I found a website with fairly high reviews and where one can buy bulk - "Flex Technologies" I wanted to confirm that I am ordering the right sizes - 3mm - 8mm -10mm Missing an sizes?

KLF - Thanks your the reply - What Segment did you need to replace and what's the reason for replacing if everything is being pulled anyway? Not 100% up to date with how my A/C works but can't wait to start the learning process.

Pappy - thanks for all the insight - Not sure of I missed this when searching.

Old Post from the grave... Do you notice any change removing your a/c belt and if so what do you notice? On this same topic I want to completely delete my R12 system - at least it's on my mind every time the weather is nice. Has anyone swapped over an R134a compressions and system? Thoughts...